Quantum Audio QXA2500PRO Installation And Owner's Manual

Summary of QXA2500PRO

  • Page 1

    Limited warranty t e l : 9 5 6 -4 2 8 -4 2 6 3 f a x : 9 5 6 -4 2 1 -4 5 1 3 w w w .Q u a n tu m a u d io .N e t mosfet power amplifiers installation instructions owner's manual tel: (956) 428-4263 fax: (956) 421-4513 www.Quantumaudio.Net quantum audio warrants any products purchased in the u.S.A. F...

  • Page 2

    1 congratulations on your purchase of a quantum audio ® state-of-the-art power amplifier. Your selection of a quantum audio ® car audio product indicates a true appreciation of fine musical reproduction. Whether adding to an existing system or including your quantum audio ® amplifier in a new system...

  • Page 3

    3 4 line out full range line outputs have been provided for convenient connection to additional amplifiers in the system. The outputs are buffered to reduce signal loss. Please note that the amplifier’s input level adjusts these level outputs. Power fusing this protects the amplifier against short c...

  • Page 4

    5 6 before you start the installation, it will be necessary to find a mounting location for the amplifier. Find a location in which the amplifier will receive adequate ventilation in order to dissipate the heat it develops during operation. Two popular mounting locations are in the trunk or under th...

  • Page 5

    2 channel stereo speaker connection signal connections speaker connections connect the rca output of the head unit (am/fm cassette player, cd, or dat) to the rca input terminals of the amplifier. To make these connections, we recommend high quality rca cables, which are available at your local car a...

  • Page 6

    Bi speaker connections (bridged) bridged speaker connection (4 ohm minimum).

  • Page 7

    Qxa series qxa adjusting the crossover and bass fine tune the system.

  • Page 8

    Troubleshooting the system qxa2500pro output power : 4 ohms 2 x 200w 2 ohms 2 x 400w rated @ 4 ohms 2 x 125w bridged @ 4 ohms 1 x 800w frequency resp. 10hz - 25khz s/n ratio (a-weight) >90db thd with 80k filter low input level 285mv - 6v crossover freq. (low) 50hz - 250hz crossover freq. (high) 90hz ...