Quantum QR5 Installation And Programming Manual - page 13
INSTALLATION AND PROGRAMMING MAN
file:///C|/PACH%20&%20COMPANY/QUANTUM%20MANUAL%202009/Quantum%20QR5-1/Quantum%20QR5.htm[5/6/2010 3:12:40 PM]
MASTER CODE RETRIEVAL BUTTON
The default Master Code is 0000. If case the Master Code has been forgotten, you may
press and release the button to log on to programming, the screen will show as below
SPEAKER AND MICROPHONE
Speaker = 8.7 ohm
Microphone = 1.542 kOhm
RADIO RECEIVER
The Quantum QR5 has built-in Radio Frequency (RF) Receiver. The transmitter is not
included.
POWER SWITCH
The power switch must be in the OFF (left position) during the installation to avoid any
damages to the board. Check all the wiring, then turn the power switch ON (right position).
The system will initialize and the display will show scrolling message as shown partially
below