Quantum Rehab DX Basic Operation Instructions

Manual is about: Scanner Control

Summary of DX

  • Page 1

    Dynamic dx scanner control basic operation instructions tm.

  • Page 2

    2 basic operation instructions dx scanner copyright © 2001 pride mobility products corporation this manual describes basic operation for the dynamic dx scanner control only and must be read in conjunction with the owner’s manual supplied with your power chair. Please read both manuals in their entir...

  • Page 3

    Dx scanner basic operation instructions 3 table of contents introduction ................................................................................ 4 dynamic dx scanner control ................................................................... 4 select mode ......................................

  • Page 4: Dynamic Dx Scanner Control

    4 basic operation instructions dx scanner introduction welcome to quantum rehab, a division of pride mobility products corporation (pride). Quantum rehab is dedicated to the customization of power chairs for users with advanced rehabilitation and mobility issues. Quantum rehab also expands possibili...

  • Page 5

    Dx scanner basic operation instructions 5 figure 1. Scanner control components and connections back of module drive mode led indicates if the drive mode is powered on or off. Environmental mode led indicates if environmental mode is powered on or off. Direction leds a set of 8 leds which indicate dr...

  • Page 6

    6 basic operation instructions dx scanner select mode 1. Press the on/off button on the dx compatible master remote used on your power chair. The module status led on the scanner will light up, indicating that it is in standby mode and ready for use. 2. Press the select switch once to activate the s...

  • Page 7

    Dx scanner basic operation instructions 7 seat mode 1. Press the select switch when the seat mode led is lit. Once selected, the scanner will cycle clockwise around the seating commands (directional leds). Figure 3. Actuator selections 2. There are four seat positioning actuators represented by two ...

  • Page 8

    8 basic operation instructions dx scanner environmental mode 1. Press the select switch when the environmental mode led is lit. Once selected, the scanner will cycle clockwise from the top (forward) led. See figure 2. 2. The first four leds are momentary selections, and the last four leds are latchi...

  • Page 9

    Dx scanner basic operation instructions 9 notes.

  • Page 10

    10 basic operation instructions dx scanner notes.

  • Page 11

    Dx scanner basic operation instructions 11 notes.

  • Page 12: Exeter, Pa

    12 basic operation instructions dx scanner exeter, pa quantum hotline: 1-866-800-2002 visit the rehab zone at: www.Quantumrehab.Com infmanu1747/a/july 2001 tm.