Quantum Rehab kids rock 2 User Manual - page 11
11
“Movement is life!”
A. SEAT DEPTH ADJUSTMENT
1. Remove the seat cushion.
2. Use a 5/32” hex wrench to loosen the screws [A] on the left and
right tubes.
3. Loosen any accessories that prevent the seat pan from sliding.
4. Push or pull on the front of the seat, evenly on both sides, until the
seat reaches the desired depth.
5. Tighten the hex screws [A] and any accessories loosened in step 3.
6. When the seat depth is changed, the glide blocks [B] must be
adjusted for proper active motion. Follow these steps carefully:
a. Set the hip angle adjustment to a position that best accommodates
the child. This will allow for accurate positioning of the glide
blocks.
b. Using a 5/32” hex wrench, loosen the adjustment bolts [C] on
the left and right glide blocks.
c. Position the glide blocks so that the top of the curve on the
glide blocks are behind the front tube touching on the bottom of
the shell frame. The blocks should touch the extrusion (Fig. 2).
d. Tighten the bolts [C] and verify that the glide blocks [B] cannot
move. Cycle active motion to verify smooth operation. If
socket head bolt at location D contacts glide block, glide blocks
need to be moved inward.
e. Reposition the hip angle as desired.
V. SET-UP & ADJUSTMENT
Tools Required:
5/32” Hex Wrench
7/16” Nut Driver
3/4” End Wrench (Active Tension Only)
1-1/8” End Wrench (Adj. Position Axle Only)
Figure 2: Proper Glide Rest Adjustment
A
B
C
D
Figure 1: Seat Depth Adjustment
WARNING: Improper adjustment of the glide block can create a pinch point for
the child. Always adjust the glide block as indicated in the above instructions.