Quantum SAR 1000 Operating Manual - Quantum
©
200
8
GB
Page 3
13/2/2008
Version 1.1.3
SAR 750 / SAR 1000
Universal device
quantum
M A S C H I N E N - G E R M A N Y
Unpacking and installation
2
Unpacking and installation
INFORMATION
The universal device is preassembled. When the machine is delivered, check immediately that
the universal device has not been damaged during shipping and that all components are
included. Also check that no fastening screws have come loose.
2.1
Extent of supply
•
universal device SAR
•
1 x stop bar which stops at the rear
•
1 x stop bar which stops in the front
•
1 x instruction manual
2.2
Installation and assembly
WARNING!
Use of unstable lifting and load-suspension gear that might break under load can cause
very serious injuries or even death.
Check that the lifting and load suspension gear is of sufficient load capacity and in per-
fect condition.
Observe the regulations for prevention of accidents.
Fasten the loads properly.
Do not walk under lifted loads!
If the universal device is not placed directly on the ground, for example, when it is used on a
construction site, the universal device should be fixed on the provided substructure which is suf-
ficiently capable of bearing, using the designated drill-holes. Please note that there might be
additional danger of overturning when using levers.
WARNING!
The universal device may overturn when it is not fixed good enough.
2.2.1
Fixing
ATTENTION!
Fix the universal device at the designated drill-holes (4 pcs) onto the subsoil.
Illustr. 2-1: SAR_installation