Quantum Scalar LTFS Replacement Manual - Removing A Hard Drive Blank
Other manuals for Scalar LTFS:
Power Supply Replacement, Rail Replacement
of
4
Quantum Scalar LTFS Appliance: Hard Drive Blanks Replacement
6-68094-01 Rev A
December 2013
2
Removing a Hard Drive Blank
Required Tools: None.
Removing a Hard Drive Blank
Caution: To prevent overheating, do not leave a slot open for more than 5
minutes.
To remove a hard drive blank, complete the following steps:
1 If installed, remove the front bezel:
a Unlock the key lock at the left end of the bezel (see
Figure
1
).
b Lift the release latch next to the key lock.
c Rotate the left end of the bezel away from the front panel.
d Unhook the right end of the bezel and pull the bezel away from the
chassis of the top Scalar LTFS Appliance.
Figure 1 Removing the Scalar
LFTS Appliance Bezel
Key lock (Step 1a)
Bezel (Step 1c)
Release latch (Step 1b)
Hook (Step 1d)
Chassis