Quatech LANPX-1G User Manual - Hardware Installation
May/07
MN7000000013
4
Hardware Installation
General instructions for installing the card are provided below. Since
the design of system may vary, refer to your system’s reference manual
for further information, if needed.
Insert the Gigabit Ethernet ExpressCard into the ExpressCard slot of
your system. Make sure it is inserted all the way in for a solid
connection.
For Windows® 2000/XP/Server 2003
Once the Windows® 2000, XP and Server 2003 startup. The Gigabit
Ethernet ExpressCard will be detected by system. Follow the procedure
below to install the Gigabit Ethernet ExpressCard driver under
Windows® XP Service Pack 2.
1.
When the
Found New Hardware Wizard
window pops up,
please click
“Cancel”
to cancel the driver installation for the
device. The driver for this device will be installed in the next step.
2.
Please insert the CD that came with your Gigabit Ethernet
ExpressCard into your CD-ROM Drive.
3.
At the Windows desktop click
Start
, then
Run
.
4.
Type
D:\Drivers\ExpressCard\LANPX-1G\Setup.exe
, then
click
OK
.