Quatech SSCF-200 User manual

Manual is about: Quatech One Port RS-422/485 Serial CompactFlash Card

Summary of SSCF-200

  • Page 1

    Quatech, inc. 5675 hudson industrial parkway hudson, ohio 44236 tel: (330) 655-9000 fax: (330) 655-9010 http://www.Quatech.Com. Compactflash card user’s manual p/n: 940-0190-110 version 1.10, 02.05.04 user’s manual sscf sscf--200/300 200/300 one port rs-422/485 serial compactflash card.

  • Page 2

    - 2 - (c) 2003-2004, quatech, inc. This manual is copyrighted. All rights are reserved. The information contained in this document cannot be reproduced in any form without the written consent of quatech, inc. Likewise, any software programs that might accompany this document can be used only in acco...

  • Page 3

    Quatech compactflash card user’s manual sscf-200/300 - 3 - table of contents 1. Overview ---------------------------------------------------------------------------------------------------4 2. About the sscf-200/300------------------------------------------------------------------------------4 3. In...

  • Page 4

    Quatech compactflash card user’s manual sscf-200/300 - 4 - 1. Overview the sscf-200/300 card is a single port rs-422/485 serial compactflash card with the following features: • type i compactflash form factor for cf+ equipped pdas, handheld, laptop, & tablet pcs windows 95/98/me/2000/xp/ce, pocketpc...

  • Page 5

    Quatech compactflash card user’s manual sscf-200/300 - 5 - 3. Installing the sscf-200/300 3.1 windows ce, pocketpc there is no need to install any software for windows ce or pocketpc. Simply insert the sscf- 200/300 card and it will appear in a list when you set up a “connection.”for more informatio...

  • Page 6

    Quatech compactflash card user’s manual sscf-200/300 - 6 - 5. Hardware specification 5.1 pinout the sscf-200/300 is supplied with a 300mm long type 46 cable that terminates with a db9 male connector with female screwlocks (to match the port at the back of a pc) the pin-out below applies to both the ...

  • Page 7

    Quatech compactflash card user’s manual sscf-200/300 - 7 - 5.2 electrical all figures quoted are typical parameters @ 25°c esd protection: all rs-422/485 signal lines on the sscf-200/300 card are protected against electrostatic discharge (esd) • >1kv – iec1000-4-4 uart clock speed: x1: uart clock is...

  • Page 8

    Quatech compactflash card user’s manual sscf-200/300 - 8 - 5.6 notes on serial data throughput the maximum serial baud rate of 921kbits/sec does not imply that the maximum sustained throughput rate of the serial port will be as high. The actual throughput rate that can be achieved depends on many fa...

  • Page 9

    Quatech compactflash card user’s manual sscf-200/300 - 9 - 6. Using the sscf-200/300 card 6.1 termination rs-422 and rs-485 lines should be terminated at the end of the main branch of the receiver with the cables characteristic impedance. These terminating impedances reduce signal reflections at the...

  • Page 10

    Quatech compactflash card user’s manual sscf-200/300 - 10 - 6.4 rs-422 operation generally, in rs-422 systems, all 8 signal lines from the db9 connector are used. Thus 4 twisted pair cables are used, one pair for each of the 4 signals txd, rxd, rts and cts. The rs-422 arrangement allows data to be t...

  • Page 11

    Quatech compactflash card user’s manual sscf-200/300 - 11 - 7. Warranty information 7. Warranty information quatech, inc. Warrants the sscf-200/300 to be free of defects for five (5) years from the date of purchase. Quatech, inc. Will repair or replace any board that fails to perform under normal op...