Quba M30 User Manual - page 5
Be careful to remove it before the assembly.
Turn off the M30 mobile phone, and remove the other
external power supply and battery.
Slide the SIM card into the SIM card holder.
When you need to remove the SIM card, first turn off the
mobile phone, remove the other external power supply
and battery, then remove the SIM card.
2.1.2 Insert and remove memory card
Turn off the M30 mobile phone, and remove the other
external power supply and battery.
Put the memory card into the memory card seat, and
lock memory card into the slot.
When you need to remove the memory card, first
turn off the M30 mobile phone, remove the other
external power supply and battery, then remove the
memory
card.
2.1.3 Remove and install battery
Install the battery according to the following steps:
Make the golden contacts of the battery face to the
Contacts in phone. Gently press the other side of the
battery to finish installing.
To replace the back cover, carefully align the top
lugs, and line up the back cover, then gently press
down until the cover locks into place.
Battery removal and installation steps are opposite.
Warning: Before remove the battery, be sure the
M30 is off.
2.1.4 Charging the QUBA battery
Plug the charger into the socket of your M30
phone . Connect QUBA charger to an AC wall outlet
.
When the battery is fully charged, disconnect the
charger from the device, then from the wall outlet.
Before first use, fully charge the battery.
During charging , the battery , mobile phone and
charger will become hot, this is normal.
When charging, the mobile phone must be placed in
an ambient temperature of -10
~ +45
for
ventilation.
3 Key explaination
Note: In this manual, press a key refers to press
and then release the key; Long press a key refers
>>
6
7