Um_en part no.: 1730015_02 hva/hvm user manual.
2 hva/hvm content content ........................................................................................................................................................ 2 general ..................................................................................................................
3 hva/hvm general introduction thank you for choosing a hva/hvm hot water machine. We hope you enjoy it ! Read the user guide before using the machine. This guide contains important instructions for proper and safe use of the vending machine. Always keep this guide close at hand for future reference...
4 hva/hvm general facts & weight facts hva/hvm 1 phase hva/hvm 3 phase height, width, depth 500, 225, 410mm 500, 225, 410mm tank volume 7.5 litres 7.5 litres power supply 220-230vac 1n~ 2200w 50/60hz 380vac 3n~6600w 50/60hz cold water connection ½” external thread ½” external thread capacity 18 litr...
5 hva/hvm overview of components hot water tap display temperature adjustment buttons drip tray insert drip tray power switch water connection back front.
6 hva/hvm place the machine on a flat and waterproof surface that will support the weight of the machine. Make sure air is able to circulate behind the machine (minimum 10cm). Installation and start-up positioning start-up procedure min. 10cm note connect the supplied water hose to the cold water co...
7 hva/hvm a b installation and start-up adjusting water temperature dispensing hot water adjust water temperature by pressing the buttons on membrane switch. Max temperature 96ºc min temperature 70ºc place a glass or decanter under the hot water tap.(a) pull down the tap handle to start dispensing w...
8 hva/hvm exterior cleaning when necessary cleaning and care to clean the exterior of the machine, use a soft cloth and liquid cleaning agent that is non-abrasive..
9 hva/hvm error messages level control temperature control shown on the display possible fault possible solution - the high water level sensor is triggerd before the low level sensor. - clean the level sensor. - replace. - cables connected is incorrectly. - the machine fills slowly. - poor water pre...
10 hva/hvm programming set machine for manual water filling install the cover plug at the inlet valve (e) to avoid possible leakage. Note the display will show t1, change the type of machine with buttons (b) or (c). T1 = hva automatic t2 = hvm manual confirm the choice by holding down the buttons (b...
11 hva/hvm dimension sketch model a b c d e hva/hvm 1 phase 500mm 225mm 410mm 240mm 210mm hva/hvm 3 phase 500mm 225mm 410mm 240mm 210mm e a b d c hva/hvm.
Your dealer for service please contact your dealer www.Creminternational.Com for the warranty to be valid the conditions for maintenance must have been followed according to our instructions, proper precaution has been made and warranty claim been issued without delay. The affected equipment may not...
