Co alarm model number (located on the back of alarm): co alarm assembly number (located on back of alarm): date of manufacture (located on back of alarm): date of purchase: where purchased: battery operated c arbon monoxide alarm user’s guide for questions concerning your carbon monoxide alarm, plea...
Contents contents of this manual carbon monoxide overview.................................................3 alarm / danger levels........................................................4-5 quell product view & quick set-up..................................6-7 installation instructions..................
Carbon monoxide overview your new quell carbon monoxide (co) alarm is a sophisticated instru- ment that has been carefully designed and tested to detect co build up in a residential environment. Your alarm is for use specifically in the home. Co cannot be seen, smelled or tasted and can be fatal. Th...
Caution: this co alarm will only indicate the presence of co at the sensor. Co may be present in other areas. Familiarisation with the effects of each level is important. The symptoms described above are related to carbon monoxide poisoning and should be discussed with all members of the household. ...
Because carbon monoxide is a cumulative poison, long-term expo- sures to low levels may cause symptoms, as well as short-term exposures to high levels. This quell unit has a time-weighted alarm - the higher the level of carbon monoxide present, the sooner the alarm will be triggered. This co alarm c...
Carbon monoxide alarm c a u t io n : d o no t p ain t, additional m ar kin g o n b a c k test/ reset operate alarm move to fresh air model no. Q9co5 km 98848 en 50291:2001 9co5 non-digital model quell product view 6 2525-7205-01(820-1384-au b).Qxd:_ 2011.5.10 4:38 pm p.
Quick set up note: this co alarm must be installed by a competent person. Remove the three enclosed aa batteries and install them into the battery well. Carefully place the red battery warning flags into the battery well. Observe the battery polarity markings at the bot- tom of the battery well. Aft...
Dining kitchen bedroom bedroom bedroom living room installation instructions installation location when choosing your installation locations, make sure you can hear the alarm from all sleeping areas. If you install only one carbon monoxide alarm in your home, install the alarm near the bedrooms. If ...
Where to install your quell co alarm the following suggestions are intended to help you with the placement and installation of your quell co alarm. • place out of the reach of children. Under no circumstance should chil- dren be allowed to handle or install the co alarm. • install in a bedroom or ha...
V) obstructions in or unconventional vent pipe designs which can amplify the above situations. 2) extended operation of unvented fuel burning devices (cooker, oven, fire- place, etc.). 3) temperature inversions which can trap exhaust near the ground. 4) car idling in open or closed garage, or near t...
Features and operation of digital display and non-digital display models test/reset button the test/reset button is used to test the unit’s electronics and to reset the unit during alarm. Test the unit: • test the unit - to test, press and release the test/reset but- ton, you should hear one short b...
Features and operation of digital display and non-digital display models lights red alarm indicator light if stated levels of carbon monoxide are detected by your quell alarm, the red alarm led will flash on and off continuously and a loud (85 decibel) alarm will sound. Green operate light the green...
Battery installation/replacement installation/replacement since batteries are not installed in the unit at the factory, you will need to install them. Your quell unit will continue to remind you to change the batteries for up to seven days after low batteries are detected. Warning: your quell co ala...
Battery installation/replacement 3. Reinstall the new batteries. Be careful to seat the red battery warning flags in the recess of the battery well. Also, note the polarity illustration in the bottom of the battery compartment. If applicable, the unit will chirp and display for approximately one min...
What to do when the alarm sounds ▲ ! Warning: actuation of your co alarm indicates the presence of carbon monoxide (co) which can kill you. When the co alarm senses a dangerous level of co, the unit will emit a loud alarm pattern. If the alarm sounds: 1) operate the test/reset button - to silence al...
Caring for your quell battery powered co alarm to keep your co alarm in good working order, please follow these simple steps: • verify unit alarm, lights and battery operation by pushing the test button once a week. • vacuum the co alarm cover with a soft brush attachment once a month to remove accu...
Product specifications 17 power : three aa batteries (supplied) sensor : electrochemical carbon monoxide sensor accuracy : depending on the ambient condition (temperature, humidity) and the condition of the sensor, the alarm readings may vary. The digital reading toler- ances are: ambient: 27°c +/-1...
18 warranty & contact details chubb fire & security pty ltd acn 000 067 541 149-155 milton street, ashfield nsw 2131 australia telephone: 1800 654 435 website: www.Quell.Com.Au chubb new zealand limited 3 fisher crescent, mt wellington , auckland, new zealand telephone: 09 270 7288 website: www.Quel...
