Quesh Ltd I-CAPTURE 45465 User Manual - page 4
3
44
Battery Handling and Usage
Battery Safety
•
Never throw batteries into fire or expose to excessive heat sources.
•
If batteries are swallowed, please seek immediate medical attention.
•
Ensure correct +/- polarity when installing batteries.
•
Do not recharge non-rechargeable batteries.
•
Do not combine old and new batteries.
Helpline No. UK/Northern Ireland 01270 508538 Rep.Ireland 1800 995 036
Web Support www.quesh.co.uk
Model No: 45465
Battery Backup / Replacement
This product uses a battery back up system to
provide continuous alarm operation and clock
settings in the event of a power failure. Please
replace the batteries if the clock or alarm stop
working. Ensure the product is connected to
mains power when replacing the batteries.
This will ensure the settings are not lost. To
replace the batteries, open the battery
compartment located on the underside of the
product and insert 2 x AAA size batteries as
per the diagram on the right. Always ensure
the correct +/- polarity when inserting new
batteries.
The remote control uses 1 x CR2032 type battery which is already installed. Please
remove the clear plastic battery insulator tab before use. If the remote control stops
working or its range is reduced, please replace the battery with a new one.
Remote Control
1.
The battery compartment is located at the bottom of the remote control.
2.
Pull out the battery compartment.
3.
Insert 1 x CR2032, 3 volt lithium battery ensuring the correct polarity.
4.
Slide the battery compartment back into place.
4