Quick Charge OBET Operating Instructions

1

C O R P O R A T I O N

O    P    E    R    A    T    I    N    G        I    N    S    T    R    U    C    T    I    O    N    S

!

!

Quick Charge Corp.   1032 S.W. 22nd St.   Oklahoma City, OK. 73109   800 658-2841

OBET, OBETXU, ON BOARD Battery Chargers

INTRODUCTION:

The OBET line of chargers are designed for the permanent installation on battery powered

vehicles and equipment. They are an electronically controlled timed shut off charger. The

batteries are brought to the gassing threshold where a timer starts. At the end of three hours, the

charger shuts off. 

SOME APPLICATIONS:

Golf cars, pallet trucks, personnel carriers, scissor lifts, floor scrubbers, robotics.

IMPORTANT: DO NOT USE THIS CHARGER UNTIL YOU HAVE READ ALL THE

INSTRUCTIONS.

INITIAL INSTALLATION:

Before making AC connections, refer to the AC requirements labeled on the charger. If your

charger is not equipped with an AC plug (a 220 volt model) have a qualified electrician install

one.

CAUTION: To reduce the risk of fire, use this charger only on circuits provided with 

          a maximum of 20 ampere branch circuit protection (circuit breaker or fuse), 

    In accordance with the National Electric Code, ANSI/NFPA 70, and all local 

    codes and ordinances.

GROUNDING INSTRUCTIONS: 

This battery charger must be grounded to reduce the risk of electric shock. If the charger is

equipped with a grounding type plug, it must be plugged into a nominal 115 volt, 60 Hertz

circuit. If the charger is supplied with no plug, have a qualified service person install one.

WARNING: Improper connection of the equipment grounding conductor can result in a        

                       risk of an electric shock. DO NOT USE THIS CHARGER ON A TWO         

                             POLE UNGROUNDED OUTLET OR ATTEMPT TO BREAK OFF THE 

                            GROUND PRONG FOR USE ON A RECEPTACLE OR EXTENSION    

                 CORD NOT HAVING A GROUND. 

The use of an extension cord with this charger should be avoided. The use of an improper

extension cord result in a risk of a fire or electric shock. If an extension cord must be used, make

sure it is in good condition. Use a three conductor cord no smaller than 16 AWG. And keep it as

short as possible. Locate all cords so that they will not be stepped on, tripped over, or otherwise

subjected to damage or stress.

Do not operate this charger if  it shows any signs of physical damage.