Quickie IRIS User Instruction Manual & Warranty - page 15
931134 Rev. A
I X . S e t - u p & A d j u s t m e n t
29
I X . S e t - u p & A d j u s t m e n t
931134 Rev. A
28
D. ARTICULATING LEGREST (OPTIONAL)
1. Installation or Removal
To install or remove Articulating Legrest (ALR) see
instructions for Swing-away Footrest installation.
2. Elevation Adjustment
a. To raise legrest, lift to desired position. Legrest
will automatically lock in place.
b. To lower legrest, while seated in chair, press
release lever (A) down and lower Legrest to
desired position. Legrest will automatically lock
in place.
3. Height Adjustment of the Calf Pad
a. Rotate the tube clamp (B) towards the outside.
b. Slide it up or down.
c. Rotate it back in the desired indented position.
4. Height Adjustment with Extension Tube
a. Remove the bolt (C) in the hanger frame tube.
b. Reposition footrest height.
c. Align the tube clamp with the selected bolt.
d. Re-tighten the bolt (C).
E. ELEVATING LEGREST (OPTIONAL)
1. Installation or Removal
To install or remove Elevating Legrest (ELR) see
instructions for Swing-away Footrest installation.
2. Elevation Adjustment
a. To raise legrest, lift to desired position. Legrest
will automatically lock in place.
b. To lower legrest, while seated in chair, press
release lever (D) down and lower legrest to
desired position. Legrest will automatically lock
in place.
3. Height Adjustment of the Calf Pad.
a. Loosen the retaining nut (E) located at the
back of the calf pad bracket assembly.
b. Slide the calf pad bracket assembly up or down.
c. Tighten it in the desired position.
4. Height Adjustment with Extension Tube
a. Loosen both bolts (F) in the hanger frame tube.
b. Reposition footrest height.
c. Re-tighten all bolts (F).
A
D
E
B
C
F
B. HEAVY-DUTY, LIFT-OFF FOOTRESTS (OPTIONAL)
1. Installation
Slide pivot saddle (A) into receiver (B) on front frame
tube until it locks into place.
2. Removal
To remove footrest, push release latch (C) while lifting
up footrest from receiver.
3. Height-Adjustment, Front Mount
a. Loosen and remove the retaining bolt (D) in the
footrest mounting bracket.
b. Position footplate upward or downward in
predrilled holes on hanger tube.
c. Reinsert bolt and tighten.
C. CONTRACTURE FOOTREST (OPTIONAL)
1. Lateral Mount
Can be mounted laterally as shown in illustration (E).
2. Center Mount
Can be mounted in the center as shown in illustration
(F).
3. Height Adjustment
a. Loosen and remove the retaining bolt (G) in the
footrest mounting bracket.
b. Slide the lower tube upward or downward to the
desired position until predrilled holes on hang-
er tubes are aligned.
c. Reinsert bolt and tighten.
4. Footrest Angle Adjustment
a. Loosen the retaining bolt (H) in the adjustment
locking joint.
b. Position footrest foreword or rearward in desired
angle.
c. Retighten the bolt.
5. Footplate Angle Adjustment
a. Loosen the retaining bolt (I) in the footplate
locking joint.
b. Position footplate upward or downward in
desired angle.
c. Retighten the bolt.
I
A
B
C
D
E
F
G
H