810 arvor owner’s manual.
Welcome iii congratulations on becoming a new owner of a quicksilver® boat. This owner’s packet will provide important information about the features of your boat and should be, at all times, kept aboard your boat. Take time to carefully review the information in this packet to really get to know yo...
Iv information in this publication is based upon the latest production specifications available at printing. Quicksilver® reserves the right to make changes at any time, without notice, in the colors, equipment, specifications, materials and prices of all models, or to discontinue models. Should cha...
Table of contents v introduction 1. Owner’s manual .......................................... Vi 2. Your responsibilities .................................... Vi 3. Safety / warning labels ............................... Vi 4. Dealer responsibilities ................................ Vii 5. Craft ide...
Introduction vi danger—immediate hazards which will result in severe personal injury or death if the warning is ignored. Warning—hazards or unsafe practices which may result in severe personal injury or death if the warning is ignored. Caution—hazards or unsafe practices which could result in minor ...
Introduction vii 4. Dealer responsibilities in addition to a pre-delivery check and service of the boat, your dealer is to provide: a description and demonstration of the safety systems, features, instruments and controls on your boat an orientation in the general operation of your boat a review of ...
Introduction viii the quicksilver division of brunswick marine in emea (quicksilver®) provides the following limited warranty to the original retail owner of its quicksilver® boat, if purchased from an authorized dealer and operated under normal, subject to remedies, exclusions, and limitations set ...
Introduction ix 3. Rainwater leakage, including rainwater leakage through convertible tops 4. Damage or deterioration of cosmetic surface finishes, including cracking, crazing, discoloration, air voids, fading or oxidation of gel coat, wood finishes (varnishes, stains, and paints), fabrics, vinyls, ...
Introduction x statute of limitations: any action for rescission or revocations against brunswick marine in emea shall be barred unless it is commenced within one (1) year from the date of accrual of such cause of action. This provision does not grant any consumer a right of rescission or revocation...
Introduction xi what is not covered: as expressly set out herein, all warranties provided by the manufacturers and distributors of components, equipment, and parts (“component manufacturer”) on the boat are hereby assigned to the owner, to the extent permitted by the component manufacturer, as the o...
Introduction xii some countries, states or regions do not allow limitations on how long an implied warranty lasts, so the above limitations may not be applicable. Some countries, states or regions do not allow the exclusion or limitations of incidental or consequential damages, so the above limitati...
Quicksilver 810 arvor — general information 1 1. Basic boat dimensions & specifications manufacturer: brunswick marine in emea model: quicksilver arvor 810 design category: b length of hull (l h ) : 7.19m length overall (l max ): 8.30m beam of hull (b h ): 2.88m beam max (b max ): 2.93m draft max (t...
Quicksilver 810 arvor — general information 2 2. Vessel stability the following maximum load has been used for assessing the stability and buoyancy comprising manufacturer’s maximum recommended load per iso 14946 715kg fuel, fresh water, other fluids to maximum capacity of fixed tanks 490kg this ass...
Quicksilver 810 arvor — general information 3 when people are on the working deck area for anchoring, mooring, or in emergencies, they must be holding on and be positioned as to prevent falling overboard. 5. Design categories there are four design categories of boats based upon their ability to with...
Quicksilver 810 arvor — general information 4 6. Safety label locations.
Quicksilver 810 arvor — general information 5 safety label locations.
Quicksilver 810 arvor — general information 6 7. Deck / cockpit layout anchor roller bow windlass bow cleat (p&s) bow rail (p&s) hardtop navigation lights (p&s) hardtop rail (p&s) sliding window (p&s) midship cleat (p&s) water deck plate waste pumpout rod holder (p&s) coaming cap (p&s) cockpit flip ...
Quicksilver 810 arvor — general information 7 8. Cockpit storage quicksilver® recommends that the liferaft store in the aft cockpit hatch area. Do not store any equipment containing petrol (outboard engines, portable petrol tanks, etc.) in any interior storage areas. These compartments were not desi...
Quicksilver 810 arvor — general information 8 9. Thru hull locations depending on the type of boat, you may have underwater fittings that need drain plugs. Garboard drain plugs and fishbox drain plugs need to be in place before the boat goes in to the water. Any fitting that will be underwater needs...
Quicksilver 810 arvor — general information 9 gps smartcraft tm gauges stereo 12v outlet usb receptacle helm switches steering wheel bow thruster control trim tab switches fire extinguisher override windlass switch trolling valve control engine throttle shift control 10. Dash layout please note that...
Quicksilver 810 arvor — general information 10 360 o all around light (white), visible 2nm 112.5 o stbd navigation light (green), visible 2nm all around light folds downs on the hardtop 112.5 o port navigation light (red), visible 2nm 12. Engine your boat is propelled by a single mercury diesel inbo...
11 quicksilver 810 arvor — system & component overview and operation 1. Fuel system your boat’s diesel fuel system consists of a fuel tank, a fuel tank fill and vent fitting, a sending unit, a shutoff valve, an engine fuel supply line, and an engine fuel return line. In addition, there is an inline ...
Quicksilver 810 arvor — system & component overview and operation 12 removed and the tank completely dried before refilling the tank with any fuel. Check the fuel lines frequently for leaks or any surface cracking on the hose. Replace the hose immediately if any issues are found. Storage long period...
13 quicksilver 810 arvor — system & component overview and operation fresh water system water pump strainer water pump galley faucet hose galley faucet water tank fill water tank vent water tank vent hose water tank fill hose water tank water tank to water pump hose 3. Black water system (optional) ...
Quicksilver 810 arvor — system & component overview and operation 14 black water system overboard discharge holding tank to pumpout hose pumpout deck plate holding tank to vent filter hose vent filter vent filter to tank vent thru hull hose tank vent thru hull toilet water pickup pickup to toilet wa...
15 quicksilver 810 arvor — system & component overview and operation check the function of all bilge pumps at regular intervals. Clear pump inlet from debris. The bilge pumping system is not designed for damage control. Dockside pumpout the dockside pumpout deck plate is located on the deck, at the ...
Quicksilver 810 arvor — system & component overview and operation 16 5. Livewell & raw water washdown this boat comes installed with a 75 liter livewell and raw water washdown system. The livewell is located in the aft cockpit, while the raw water washdown is located at the starboard aft corner of t...
17 quicksilver 810 arvor — system & component overview and operation 6. Fire suppression fire is a serious boating hazard. Boats will burn quickly. Do not remain onboard and fight a fire for more than a few moments. If the fire is out of control and cannot be put out with the fire suppression equipm...
Quicksilver 810 arvor — system & component overview and operation 18 fire extinguisher fire extinguisher 7. Carbon monoxide monitor quicksilver® boats are equipped with carbon monoxide (co) monitors in the cabin and enclosed berths or staterooms. Carbon monoxide is an odorless, colorless, tasteless,...
19 quicksilver 810 arvor — system & component overview and operation carbon monoxide accumulation & prevention carbon monoxide can accumulate in dangerous concentrations anywhere in or around your boat including on back decks, swim platforms, or in water around generator exhausts. Co can remain in o...
Quicksilver 810 arvor — system & component overview and operation 20 fumes for the engine(s), generator, lpg stoves, and other equipment that burns fuel contain carbon monoxide. Carbon monoxide can kill you. Open all doors, hatches, curtains, and windows to allow fresh air to circulate. Never ignore...
21 quicksilver 810 arvor — system & component overview and operation tank storage the lpg tank storage is located in the starboard walkthrough. The tanks must be firmly secured to the boat with the tanks in a horizontal position. Do not relocate or reposition the tanks. Do not obstruct access to the...
Quicksilver 810 arvor — system & component overview and operation 22 fuel burning open flame appliances consume cabin oxygen and release products of combustion into the craft. Ventilation is required when appliances are in use. Open designated vent openings while appliances are in use. Do not use th...
23 quicksilver 810 arvor — system & component overview and operation before operating the windlass, make sure that the safety lanyard is removed from the anchor. Operation to operate the windlass, the windlass breaker, located next to the battery switch in the aft bilge, must be turned on. Operation...
Quicksilver 810 arvor — system & component overview and operation 24 before operating the windlass, make sure that the safety lanyard is removed from the anchor. 10. Stern anchor windlass (optional) the anchor windlass located at the stern of the boat assists with the anchoring of your boat by autom...
25 quicksilver 810 arvor — system & component overview and operation continuously. Press the on/off switch again within 6 seconds . The system will confirm that it is ready for use when the led light remains green and the buzzer sounds twice. To move the bow to the port direction, push the joystick ...
Quicksilver 810 arvor — system & component overview and operation 26 12. Steering your boat comes equipped with a hydraulic steering system connected to a single rudder. The basic system for a single engine boat contains a steering wheel, a hydraulic helm pump, a hydraulic steering cylinder, hydraul...
27 quicksilver 810 arvor — system & component overview and operation 13. Engine operation your boat is powered by a mercury 2.8l closed cooled diesel engine with a transmission connected to a straight drive shaft. Prior to operation of the vessel, the following will need to be observed: engine cooli...
Quicksilver 810 arvor — system & component overview and operation 28 exhaust system your boat is equipped with a thru hull exhaust system with an inline muffler located on the starboard side of the boat. Water from the cooling system enters the exhaust system through the engine exhaust manifold, whe...
29 quicksilver 810 arvor — system & component overview and operation engine controls “throttle only” button shut down switch vernier trolling control the lanyard should be long enough to prevent inadvertent activation. Do not let the lanyard become entangled. Maximum engine speed in troll mode is 12...
Quicksilver 810 arvor — system & component overview and operation 30 cabin engine control helm selector switch exterior helm engine control gear & throttle mechanism main helm exterior helm exterior helm helm control transfer to switch control from the main helm to the exterior helm, pull out and ro...
31 quicksilver 810 arvor — system & component overview and operation 10l diesel tank fuel line diesel heater hot air ducts window defroster cabin vent cold air ducts cabin return air vent exterior return air vent exhaust outlet heater controller diesel heat vision from the exterior helm station is l...
Quicksilver 810 arvor — system & component overview and operation 32 stereo stereo usb port stored position in use position flip seat seat rail flip seats 20. Stereo (optional) your boat may come equipped with a fusion am/fm stereo with bluetooth®. The stereo unit along with a usb port, is located a...
33 quicksilver 810 arvor — system & component overview and operation 23. Cockpit sunshade (optional) if installed, an optional cockpit sunshade is available to provide protection from the sun. The cockpit sunshade consists of a rail on the hardtop and a canvas. Operation to extend the sunshade, simp...
Quicksilver 810 arvor— electrical systems 34 1. Dc electrical system the dc electrical system is powered by a single battery, and is kept charged by the engine driven alternator. 2. Battery refer to your engine owner’s manual for exact battery requirements. To remove the battery cables: 1. Turn off ...
Quicksilver 810 arvor — electrical systems 35 5. Fuses and breakers your boat will either have fuses or breakers protecting the dc electrical system. If you have to replace a fuse or electrical breaker, replace only with a fuse or breaker of the same rating. The amperage will be marked on the fuse o...
Quicksilver 810 arvor— electrical systems 36 6. Ac system (optional) the ac electrical system allows you to use the following 230v appliances while docked and connected to a shore power system: 1. Battery charger the shore power receptacle is located on the port side of the cockpit next to the flip ...
Quicksilver 810 arvor — electrical systems 37 turning off and disconnecting shore power to disconnect shore power: on the boat 1. Make sure that the all of the breakers on the ac distribution panel are off on the dock 1. Turn off the dock breaker. 2. Disconnect the dockside end of the power cord. On...
Quicksilver 810 arvor— electrical systems 38 9. Electrical schematics this owner’s manual contains electrical schematics and wiring harness illustrations for your boat. These electrical schematics were generated by the electrical engineering department for technical reference and service technicians...
Quicksilver 810 arvor — electrical systems 39 dc wiring schematic.
Quicksilver 810 arvor— electrical systems 40 230v ac schematic stern windlass schematic.
41 quicksilver 810 arvor — maintenance 1. Maintenance routine inspection, service and maintenance of your boat, systems and components are vital to assure your safety, and will prolong the life of your boat. The interval between necessary service or maintenance is highly variable, depending on the e...
Quicksilver 810 arvor — maintenance 42 solvents are flammable. Exercise proper care. Wear rubber gloves during all cleaning activity. Use caution when cleaning around stitching or decorative trim as these solvents could seriously damage such areas. When staining from build-up does occur, use only cl...
43 quicksilver 810 arvor — maintenance after each use, especially if used in salt water areas, rinse the canvas completely with fresh cold water. On a regular basis, brush off any loose dirt, pollen, etc., and hose down with water and clean with a mild solution of a natural soap in lukewarm water (m...
Quicksilver 810 arvor — maintenance 44 dry the window with a soft cloth or chamois to prevent water spots. Polish with a separate cloth. Don’t leave cleaners on for long periods; immediately wash the window. Finally, don’t apply cleaners in direct sunlight or at elevated temperatures. To minimize fi...
