Quicksilver Audio Mono 100 Operating Instructions

Quicksilver Audio Mono 100 Amplifier

Operating Instructions

Thank you for purchasing the Quicksilver Audio Mono 100s.  These amplifiers are  engineered to have a very

wide bandwidth, extremely low distortion and superior dynamic range.

The output transformer used in this amplifier is based on the best designs of the past but uses superior new

materials to achieve a very high level of performance. The high frequency characteristics of this transformer

are very stable.  KT88 or KT90 output tubes may be used without the need for circuit changes or

compensation adjustments.

This is an all tube design and uses no circuit boards or transistors.

PLACEMENT

The Mono 100 Amplifiers should have at least 6 inches of ventilation space on either side and at

least 6 inches above them.  If this is not possible, then use a fan for cooling.

SPEAKER CONNECTION

Five-way binding posts are used for speaker connection.  For better sonic performance, we

recommend using the screw-down part of the post rather than banana plugs to connect your

speaker wire. Make sure the ends of the speaker leads do not touch each other.  The rating on the

back of your speaker system will determine whether you use the 4 or 8 ohm tap for the positive

lead.  Connect the negative or ground to the black post labeled C.

There is a diagram on the bottom of the amp that identifies the three posts.

SYSTEM GROUNDING

Your Mono Amplifiers come with three pronged grounded AC plugs.  In some systems, where the

preamp is also grounded, a ground loop may appear as a low level hum. Using an adaptor on the

AC plug of each amplifier, to lift the ground, will solve this problem.

3 AMP SLO-BLO FUSE

Do not use larger than a 4 amp fuse.  If a fuse blows, replace and check output tube bias.  If there

is a large change, then a tube is probably damaged.  If the bias has not changed then the cause of

the fuse blowing may be due to other problems, such as poor system grounding, unstable preamp,

shorted speaker, etc.  Interchanging the amps between channels will help localize the problem to

either the system or the amplifier.

8

C

4

Input

100K