Quicksilver Triode Mono Amplifier Operating Instructions

PLACEMENT

The Triode Mono Amplifiers should have at least  6 inches of ventilation space on either side and

at least 6 inches above them.  If this is not possible, them use a fan for cooling.

SPEAKER CONNECTION

5 way binding posts are used for speaker  connections because of their  convienience.  The output

transformer wires are silver soldered directly to the binding  posts eliminating any output wiring.

Placing the amp directly behind the speaker with a very short speaker wire will further improve

the performance.  The connection to the 4 or 8 ohm tap will be determined by the rating on the back

of your speaker system.  The C  terminal should be connected to the common, ground, or negative

terminal of your speaker.

SYSTEM GROUNDING

At least one component of your system should always be grounded.

  Your Mono Amplifiers

come with three pronged grounded AC plugs.  In some systems, where the preamp is also

grounded, a ground loop may appear as a low level hum.  Using an adaptor on the AC plug, to

lift the amplifier grounds, will solve this problem.

Quicksilver Audio Triode Mono Amplifier

Operating Instructions

Thank you for purchasing the Quicksilver Audio Triode Mono Amplifiers.  These amplifiers have been

engineered to have a very wide bandwidth, extremely low distortion and superior dynamic range.

The output transformer used in this amplifier is based on the best designs of the past but uses superior new

materials to achieve a very high level of performance. The high frequency characteristics of this transformer

are so stable that many different output tubes may be used without the need for circuit changes or

compensation adjustments.

This is an all tube design and uses no circuit boards or transistors.

This device has very high internal voltages. Never operate with the bottom removed!

Never operate your amplifers with the speakers disconnected.

To prolong the life of your amplifiers, never turn them on and off within a short period of time

(45 seconds.)

Input

100K

4      C      8

Fuse

2 amp

IEC connector