Quidway S3000-EI Series Operation Manual - page 6
Operation Manual - Port
Quidway S3000-EI Series Ethernet Switches
Chapter 1 Ethernet Port Configuration
Huawei Technologies Proprietary
1-5
Table 1-6
Set the type of the cable connected to the Ethernet port
Operation
Command
Set the type of the cable connected to
mdi
{
across
|
auto
|
normal
}
the Ethernet port.
Restore the default type of the cable
undo mdi
connected to the Ethernet port.
By default, the cable type is
auto
(auto-recognized).That is, the system can
port.
1.3.4 Ena
After enabling flow control in both the local and the peer switch, if congestion occurs in
th
the peer
switch receives this message, it will pause packet sending, and vice versa. In this way,
p
ion of the Ethernet port can be
enabled or disabled through the following command.
erform the following configuration in Ethernet port view.
Note that, the settings only take effect on 10/100Base-T and 1000Base-T ports.
automatically recognize the type of cable connecting to the
ble/Disable Flow Control for Ethernet Port
e local switch, the switch will inform its peer to pause packet sending. Once
acket loss is reduced effectively. The flow control funct
P
Table 1-7
Enable/Disable Flow Control for Ethernet Port
Operation
Command
Enable Ethernet port flow control
flow-control
Disable Ethernet port flow control
undo flow-control
1.3.5 Set
he broadcast traffic. Once the
e system will maintain an
w traffic, so as to suppress
al service. The parameter is
taken the maximum wire speed ratio of the broadcast traffic allowed on the port. The
smaller the r
maller the broadcast traffic is
e ratio is 100%, it
m
m
n the port.
P
By default, Ethernet port flow control is disabled.
Ethernet Port Broadcast Suppression Ratio
You can use the following commands to restrict t
broadcast traffic exceeds the value set by the user, th
appropriate broadcast packet ratio by discarding the overflo
broadcast storm, avoid suggestion and ensure the norm
atio is, the s
allowed. If th
eans not to perform broadcast stor suppression o
erform the following configuration in Ethernet port view.