Quidway S5000 series Operation Manual

Summary of S5000 series

  • Page 1

    Operation manual - vlan quidway s5000 series ethernet switches table of contents i table of contents chapter 1 vlan configuration .................................................................................................... 1-1 1.1 vlan overview...................................................

  • Page 2: 1.1  Vlan Overview

    Operation manual - vlan quidway s5000 series ethernet switches chapter 1 vlan configuration 1-1 chapter 1 vlan configuration 1.1 vlan overview virtual local area network (vlan) groups the devices of a lan logically but not physically into segments to implement the virtual workgroups. Ieee issued the...

  • Page 3: 1.3  Display and Debug Vlan

    Operation manual - vlan quidway s5000 series ethernet switches chapter 1 vlan configuration 1-2 vlan_id specifies the vlan id. Note that the default vlan, namely vlan 1, cannot be deleted. 1.2.2 add ethernet ports to a vlan you can use the following command to add the ethernet ports to a vlan. Perfo...

  • Page 4

    Operation manual - vlan quidway s5000 series ethernet switches chapter 1 vlan configuration 1-3 1.4 vlan configuration example i. Networking requirements create vlan2 and vlan3. Add gigabitethernet0/1 and gigabitethernet0/2 to vlan2 and add gigabitethernet0/3 and gigabitethernet0/4 to vlan3. Ii. Net...

  • Page 5: 2.1  Configure Garp

    Operation manual - vlan quidway s5000 series ethernet switches chapter 2 garp/gvrp configuration 2-1 chapter 2 garp/gvrp configuration 2.1 configure garp 2.1.1 garp overview generic attribute registration protocol (garp) offers a mechanism that is used by the members in the same switching network to...

  • Page 6

    Operation manual - vlan quidway s5000 series ethernet switches chapter 2 garp/gvrp configuration 2-2 main garp configuration includes: z set garp timer note: 1) the value of garp timer will be used in all the garp applications, including gvrp and gmrp, running in one switching network. 2) in one swi...

  • Page 7: 2.2  Configure Gvrp

    Operation manual - vlan quidway s5000 series ethernet switches chapter 2 garp/gvrp configuration 2-3 note that, the value of join timer should be no less than the doubled value of hold timer, and the value of leave timer should be greater than the doubled value of join timer and smaller than the lea...

  • Page 8

    Operation manual - vlan quidway s5000 series ethernet switches chapter 2 garp/gvrp configuration 2-4 z enable/disable global gvrp z enable/disable port gvrp z set gvrp registration type in the above-mentioned configuration tasks, gvrp should be enabled globally before it is enabled on the port. Conf...

  • Page 9

    Operation manual - vlan quidway s5000 series ethernet switches chapter 2 garp/gvrp configuration 2-5 z when one trunk port is set as fixed, the system will add the port to the vlan if a static vlan is created on the switch and the trunk port allows the vlan passing. Gvrp will also add this vlan item...

  • Page 10

    Operation manual - vlan quidway s5000 series ethernet switches chapter 2 garp/gvrp configuration 2-6 ii. Networking diagram ge0/1 switch a switch b ge0/2 figure 2-1 gvrp configuration example iii. Configuration procedure configure switch a: # enable gvrp globally. [quidway] gvrp # set gigabitetherne...