Qs09-vj115 qs12-vj115 qs09-vp115 qs12-vp115 (refrigerant r410a) model: installation manual.
22 technical information service manual 1. Select the installation location according to the require- ment of this manual.(see the requirements in installation part) 2. Handle unit transportation with care; the unit should not be carried by only one person if it is more than 44lb. 3. When installing...
23 installation and maintenance service manual main tools for installation and maintenance 1. Level meter, measuring tape 4. Electroprobe 7. Electronic leakage detector 10. Pipe pliers, pipe cutter 2. Screw driver 5. Universal meter 8. Vacuum pump 11. Pipe expander, pipe bender 3. Impact drill, dril...
24 installation and maintenance service manual 8. Installation 8.1 installation dimension diagram installation dimension diagram space to the ceiling space to the wall at least 0.5ft. At least 0.5ft. At least 0.5ft. At least 8.2ft. Space to the wall space to the obstruction ro olf eht ot e ca p s sp...
25 installation and maintenance service manual preparation before installation prepare tools read the requirements for electric connection select installation location select indoor unit installation location install wall-mounting frame, drill wall holes connect pipes of indoor unit and drainage pip...
26 installation and maintenance service manual no. Name no. Name 1 indoor unit 8 sealing gum 2 outdoor unit 9 wrapping tape 3 connection pipe 10 support of outdoor unit 4 drainage pipe 11 fixing screw 5 wall-mounting frame 12 drainage plug(cooling and heating unit) 6 connecting cable(power cord) 13 ...
27 installation and maintenance service manual outlet pipe drain hose drain hose tape outlet pipe insulating pipe torque wrench open-end wrench indoor pipe pipe union nut union nut pipe joint pipe hex nut diameter(inch) tightening torque(n.M) 1/4" 15~20 3/8” 30~40 1/2” 45~55 5/8” 60~65 3/4” 70~75 re...
28 installation and maintenance service manual wiring cover screw panel power connection wire cable-cross hole do not bend the drain hose too excessively in order to prevent blocking. 7. Connect wire of indoor unit (1) open the panel, remove the screw on the wiring cover and then take down the cover...
29 installation and maintenance service manual (1) take sufficient protective measures when installing the outdoor unit. (2) make sure the support can withstand at least four times the unit weight. (3) the outdoor unit should be installed at least 3cm above the floor in order to install drain joint....
30 installation and maintenance service manual (3) the water outlet can't be placed in water in order to drain smoothly.(as show in fig.27) liquid valve gas valve refrigerant charging vent nut of refrigerant charging vent vacuum pump piezometer valve cap lo hi inner hexagon spanner open close the dr...
