Www.Quikoitaly.Com 2 30v /400v motor for sliding gates ercole use and maintenance manual qk-e3000t qk e3000 - v01_2011.
Www.Quikoitaly.Com c o n t e n t s technical features…………………………………………………………………….2 dimensions………………………………………………………………………………….2 pre-installation control…………………………………………………………...2 materials for installation…………………………………………………………3 installing the counterplate………………………………………………………3 positioning the gearmot...
Www.Quikoitaly.Com technical features dimensions before installing the automation, you must check that: - the wheels of the gate are attached to make the gate stable and must be in good condition; - the entire length of the fixed runway must be free of obstacles, straight and clean and have control ...
Www.Quikoitaly.Com materials for installation fig. B 1. Gear-motor 2. Counter plate 3. 2 end cams (or runners) 4. Nylon rack installing the counterplate fig. C dig the foundations at least 15 cm deep. Supply a protective cable sheath. Attach it to the ground using concrete, completely covering the f...
Www.Quikoitaly.Com positioning the gearmotor once the concrete has hardened, insert the screws to fasten to the counterplate or, eventually, the concrete. Fig. D installing the rack fig. E fig. E a. Gear motor b. Screws once a hole has been made in the door, fasten the rack to the gate with self-thr...
Www.Quikoitaly.Com fastening and adjusting of the end limit switches (cammes) issaggio e regolazione dei pattini di finecorsa position the end limit switches as in fig. G, each of them near an end of the rack. By manually moving the door, place the end limit switches so they activate the spring conn...
Www.Quikoitaly.Com general advice install a gate’s safety system that complies with current regulations. Choose short routes for cables and keep power cables separate from control ones. Install the control card in a waterproof box. Please refer to current regulations when setting the gear motor’s ma...
Www.Quikoitaly.Com main components 1 - gear motor 2 - photocells 3 - key selector 4 - flashing light 5 - aerial rg59 6 - photocells on little columns 7 - gate stoppers 8 - rail 9 - rack typical system electrical cables’ cross section a - 2x0,5 mm 2 b - 4x0,5 mm 2 c - 3x0,5 mm 2 d - 3x1 mm 2 e - 2x0,...
Declaration of conformity (of the manufacturer) manufacturer: quiko italy sas hereby declares, under his liability, that the products: qk- e3000, qk-e3000t are in compliance with the essential safety requirements of the regulations: electromagnetic compatibility directive .........................20...
Declaration of conformity (of the installer) the undersigned: address: in charge of the set-up, declares that the product: gate type: location: are in compliance with the essential safety requirements of the regulations: electro magnetic compatibility directive .........................2004/108/ec l...
Www.Quikoitaly.Com.
Quiko italy via seccalegno, 19 36040 sossano (vi) - italy tel. +39 0444 785513 fax +39 0444 782371 info@quiko.Biz www.Quikoitaly.Com.
