Quiko QK-KEY Installation Manual - page 2
QK-KEY Installation Guide
2
General:
The QK-KEY encoder is safe and comfortable access control products.
Get an individual access code.
The device includes an environment resistant An optional bypass pushbutton enables easy
Internal opening (the opening time is programmable)
Features:
Installation possibilities: on wall, under
plaster, inside aluminum panel
Power failure resistance, keeps the access
codes in nonvolatile memory
Easy installation, programming and
operating.
Environmental and anti vandal resistance.
Works with AC or DC power supply
Up to 100 million possible combination codes
up to 98 simultaneously different access
codes
optional bypass exit pushbutton
Different and programmable opening time
from keyboard and bypass pushbutton
Specifications:
Operating voltage: AC/DC 12V 800mA or
24Vdc
Code length: 2-6 keys
Operating electric or magnetic lock. (normally
open or normally close)
Opening time: 1-9 seconds
Dimensions: Surface Mount: 110X100X35mm
(H*W*D)
Color: silver or bronze
Installation:
Setting J5 Jumper according to the lock type
Desirable RLY state when entering the
correct code
Jumper J5
Close circuit (Normally open) for electric lock
Jumper on 2 right pins (default state)
Open circuit (Normally close) for magnetic lock
Jumper on 2 left pins
After installing the lock in the door frame. Route the following wires to the encoder:
1. 2 wires from power supply.
2. 2 wires to the lock.
3. 2 wires from optional bypass pushbutton.
Using a Phillips screwdriver open the plastic top cover screws, carefully pull up the panel.
Expose the 4 covered insulations bores and the round wires bore.
Attach the base of the encoder to the wall, using a pencil mark the 4 fixing points.
Drill the 4 fixing points on the wall.
Route the wires through the round bore in the base of the encoder.
Using 4 screws install the base to the wall.
Verify the power supply is not connected to power source!
Connect the wires to the circuit board terminals according to the circuit’s labels, the attached
electrical diagram and the following instructions.
Connect: Power supply to the two 12VAC terminals.
One wire from the lock to the RLY terminal. The second wire from the lock to one of 12VAC
terminal. Short wire from the second 12VAC terminal to the second RLY terminal.
(the RLY functions as a switch)
the polarity of the wires is not significant.
Reassemble the panel over the base.
Attach the top cover to the base using the 4 screws.
Connect the power supply to the power inlet, the red led will constantly illuminate, indicating
power supply to the encoder. The green led will blink for 2 seconds indicating correctly
initiation.