Quilter FC200-6 Owner's Manual - Contents:
Contents:
1. Six-function foot controller
2. 15' connection cable
3. Owner’s Manual
Using Your Foot Controller
Plug one end of the supplied cable into either one of the
jacks on the foot controller until you hear a “click”. Plug the
other end of the cable into the footswitch jack on the rear
of a MicroPro Series amplifier. To remove the cable, press
the plastic tab on the plug down to unlock it. Should you
lose or damage the included cable, you can substitute a
normally wired network cable with RJ-45 plugs.
(You can use one foot controller to switch two amplifiers at the same time by
connecting each amplifier to a jack on the foot controller.)
With the foot controller attached, you now have switchable control over six of
the amplifier’s functions. For better orientation, the illuminated labels above
footswitchable functions turn on and off along with the foot controller LEDs.
MODE Switch
When the footswitch is engaged (Blue LED on), the FULLQ setting is activated.
When the switch is off (LED off), the active mode will revert to the setting
indicated by the knob. If the knob is set to FULLQ, no change will occur.
BOOST Switch
When the footswitch is engaged (Red LED on), the gain boost is activated in
accordance with the settings on the amp. If the Boost Voice Selector is set to
OFF, the footswitch will not activate the boost function.
LIM Switch
When the footswitch is engaged (Amber LED on), the Overdrive Limiter is
activated. The amount of limiting is set by the amplifier’s LIM knob. If the LIM
knob is at its minimum position (fully counter-clockwise), no limiting is
applied.
TREM Switch
When the footswitch is engaged (Amber LED on), the Tremolo is activated. If
the TREM knob is at its minimum position (fully counter-clockwise), the
Tremolo will remain off.