Quinetdrive CT-20DXQD Manual - page 3
Telescoping Wand
The wand length is adjustable and
requires no assembly. To adjust,
simply push down on the wand
adjust button and slide the upper
wand to the desired height.
The swivel, located on the POWER-
HEAD allows you to turn the
handle to the left side to reach
farther under low furniture.
When raising the wand you may
have to hold the POWERHEAD
with your hand or foot.
Wand Attachment
1. To remove wands
from the POWER-
HEAD, lock wands in
straight-up position.
WA N D S & AT TA C H M E N T S
S P E C I A L F E AT U R E S
Edge Cleaner
Active brush edge
cleaners are on both
sides of the POWER-
HEAD electric brush.
Guide either side of
the brush along base-
boards or next to
furniture to help
remove dirt trapped
at carpet edges.
Overload Protector
The overload protector
protects the motor from
brush jamming and belt
breakage. If the agitator
slows down or stops, the
overload protector shuts
off the brush.
To correct problem:
Unplug the electrical cord, remove
obstruction. Check brush area for
excessive lint buildup or jamming.
To reset:
Press the reset button on top of the brush. Plug
in the power cord, turn on vacuum and brush.
Overload Protector
(reset button)
3
DO NOT attach or remove handle
or wands while cleaner is ON. This
could cause sparking and damage
the electrical contacts.
2. Press wand easy release
pedal with foot and pull
the wands straight up out
of the POWERHEAD. The
plug and cord do not have
to be removed to use
attachments on the wands.
Wand
Swivel
Wand
Length
Adjust
Button
Wand
Easy
Release
Pedal
Keep
Hand
Above
This Tab
A G I TAT O R S E RV I C I N G
To Check Agitator Assembly:
When brushes are
worn to the level
of the base support
bars, replace the
agitator assembly.
To Replace Agitator
Assembly:
1) Remove the POWERHEAD cover, belt and agitator
assembly. See “To Remove Belt” in BELT CHANGING
AND AGITATOR CLEANING.
2) Reinstall belt, new agitator assembly, and
POWERHEAD cover. See “To Replace Belt” in
BELT CHANGING AND AGITATOR CLEANING.
Electrical Shock or Personal
Injury Hazard
Disconnect electrical supply before servic-
ing or cleaning the unit. Failure to do so
could result in electrical shock or personal
injury from cleaner suddenly starting.
Base Support Bars
Belt
Wand Easy
Release Pedal
(Not Shown)
Pile Height Pedal
Handle Release Pedal
Model/Serial Number
(On Bottom)
Dirt Sensor
(Some Models)
Edge Cleaner
(Not Shown)
Overload Protector
(Reset Button)
Pile Height Indicator
Headlight and Lens
6
F E AT U R E S