Quintum Tenor DX Product Manual - page 64

6-6

P/N 480-0049-00-13

Chapter 6: Call Detail Recording

Tenor DX Establishes Connection with CDR Server

To capture CDR reports via CDR server (i.e., a PC or workstation you use to capture CDR data) you must first 

configure the IP address and port number of the CDR server in the Tenor DX unit. Once these are configured, 

the Tenor DX unit will be able to establish a TCP/IP session with the server on its own. 

CDR Server Establishes Connection with Tenor DX

If no IP address/port number is configured, the CDR server has to initiate the session. The Tenor DX unit uses 

TCP port numbers 9002, 9003, 9004, and 9005 on its side for the CDR sessions. The CDRServerport must still 

be configured to either 9002, 9003, 9004, or 9005 (see the Command Line Interface user guide for specific 

information). 

Whether the Tenor DX unit establishes the connection with the CDR server or the CDR server attempts to 

establish the connection, there is a limit of 5 attempts to enter the correct password before the TCP session is 

terminated (to configure a password, see the CLI command cdrpassword in the previous section). 

After the CDR server successfully logs into the CDR port of the Tenor DX unit, the CDR server will be pro-

vided with the IP address and unit name of the Tenor DX. The CDR server will then supply the sequence num-

ber of the last CDR that it has received from the Tenor DX unit. If the last CDR number is unknown, the server 

should send 0 for the sequence number. After this exchange, the Tenor DX will start delivering new CDRs to 

the server.