Quirky AROS User Manual - page 6
AROS
|
6
ELECTRICAL REQUIREMENTS
Aros requires a 115/120-volt AC, 60-Hz grounded outlet
protected with a 15-amp time-delay fuse or circuit breaker.
The 3-prong grounding plug minimizes the possibility of electric
shock hazard. If the wall outlet you plan to use is only a 2-prong
outlet, it is your responsibility to have it replaced with a properly
grounded 3-prong wall outlet.
CAUTION:
Do not, under any circumstances, cut or remove the third
(ground) prong from the power cord.
Do not change the plug on the power cord of this air conditioner.
Aluminum house wiring may present special problems; consult
a qualified electrician.
INSTALLATION INSTRUCTIONS
BEFORE YOU BEGIN, READ THESE INSTRUCTIONS
COMPLETELY AND CAREFULLY
• Important-Savetheseinstructionsforlocalinspector’suse.
• Important-Observeallgoverningcodesandordinances.
• Note to installer-Besuretoleavethese
instructionswiththeconsumer.
• Note to consumer-Keepthese
instructionsforfuturereference.
• Skill level-Installationofthisappliance
requiresbasicmechanicalskills.
• Completion time-Approximately1hour.
• Werecommendthattwopeopleinstallthisproduct.
• Properinstallationistheresponsibilityoftheinstaller.
• Productfailureduetoimproperinstallation
isnotcoveredunderthewarranty.
• YouMUSTuseallsuppliedpartsanduseproper
installationproceduresasdescribedinthese
instructionswheninstallingthisairconditioner.
Power cord includes a current interrupter device. A test and
reset button is provided on the plug case. The device should
be tested on a periodic basis by first pressing the TEST button
and then the RESET button while plugged into the outlet. If the
TEST button does not trip or if the RESET button will not stay
engaged, discontinue use of the air conditioner and contact a
qualified service technician.
TOOLS YOU WILL NEED
Phillips head screwdriver
flat-blade screwdriver
scissors or knife
level
ruler or tape measure
pencil