1. DL manuals
  2. QUORUM INTERNATIONAL
  3. Fan
  4. The Veranda
  5. Installation Instructions Manual

QUORUM INTERNATIONAL The Veranda Installation Instructions Manual

Summary of The Veranda

  • Page 1

    The veranda wall mounted fan installation instructions please read and save these instructions these instructions are to be used in the installation of the following quorum international fans... The veranda p.O. Box 961008 • fort worth, tx 76161 • (817) 626-5483 • fax (817) 626-5540 io220-01/14 © 20...

  • Page 2

    This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. What is covered- except as specified below, the manufacturer of this product warrants it to be free of all defects in workmanship and material. What is not covered by this warranty- 1. A...

  • Page 3

    Model #92413-xx: 14.08 lbs 1. Fan motor assembly (a) 2. Wall mounting plate, bundled wires, wall mounting plate screws (b) 3. Wall switch, 2 mounting screws and 3 wire nuts, wall plate w/2 mounting screws and 2 machine screws ( c ) unpack your fan and check the contents. Do not discard the carton. I...

  • Page 4

    1. Disconnect the power by removing fuses or turning off circuit breakers. 2. If there is an existing wall junction box, ensure it is clearly marked “suitable for fan support”. If it is not so marked, it must be replaced with an approved one. 3. Secure the wall junction box (or make sure the existin...

  • Page 5

    Fig. 5 fig. 6 warning – turn off the power. 1. Remove the two fan base screws that pre-installed on the top of the wall mounting plate, keep it for future use. 2. Install the wall mounting plate to the wall junction box and secure with six screws provided. (figure 2) 3. Remove the three wire nuts fr...

  • Page 6

    5. Electrical connections use only wall controls approved by quorum. Use of unapproved wall controls will cause unacceptable humming noise, and avoids the fan warranty. Note: the wire connection for this fan requires that a three-conductor cable with ground wire be run between ceiling and wall junct...

  • Page 7

    Restore power to the ceiling fan and test for proper operation. A. The fan 3-speed control knob is used to control the fan blade speed as follows: 0= turns the fan off 1= high speed 2 = medium speed 3= low speed “off-on” button: this button is used for oscillating operation. Press “on” to set the fa...

  • Page 8

    Fan will not start 1. Check that the electricity has been turned on at the circuit breaker which had probably been turned off during installation. 2. Turn off the electricity. Check all connections in the wiring of the fan at the wall and make sure it follows the wiring instructions outlined in this...