The windmill ceiling fan installation instructions please read and save these instructions these instructions are to be used in the installation of the following quorum international fans... The windmill p.O. Box 961008 • fort worth, tx 76161 • (817) 626-5483 • fax (817) 626-5540 i0230-10/15 © 2015 ...
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state. What is covered- except as specified below, the manufacturer of this product warrants it to be free of all defects in workmanship and material. What is not covered by this warranty- 1. A...
Model #96015-xx: 37.5 lbs 97215-xx: 44.6 lbs unpack your fan and check the contents. Do not discard the carton. If warranty replacement or repair is ever necessary the fan should be returned in original packaging. Remove all parts and hardware. Do not lay motor housing on its side - because the deco...
1. Disconnect the power by removing fuses or turning off circuit breakers. 2. If there is an existing outlet box, ensure it is clearly marked "suitable for fan support of 50 lbs (22.7 kg) or lesse". If it is not so marked, it must be replaced with an approved one. Warning: most outlet boxs commonly ...
Fig. 7 warning -turn off the power! Note: please see the label of the blade side up as illustration shown for assembly. 1. Slide the blade deco plate to position the blade hole on the center of the blade. Insert the blade deco bar into the hole in the blade and secure with a blade deco plate screws ...
Warning -turn off the power! 1. Carefully lift the blade circle to the fan assembly. (fig. 9) important assembly process, it is a must to require 3 persons at least to lift the blade circle evenly onto the fan body and positioning the blade holes at inner circle. Suggestion: 3 persons at least for t...
7. Electrical connections remember -turn off the power! Use the wire nuts supplied with your fan when making connections. Secure the connectors with electrical tape and make sure there are no loose connections or wire strands. 1. Spread the wires apart so that the black wire from the fan is on one s...
1. Make sure the wiring is safely inside the outlet box as instructed in step 5 - electrical connections. To install the canopy, slide the canopy up to hanger bracket and place the key hole on the canopy over the screw on the hanger bracket, turn canopy until it locks in place at the narrow section ...
9. Installing the wall control your dc brushless motor is equipped with an automatically learned type remote control. There are no frequency switches on the receiver; the receiver unit will automatically scan the frequency from the wall control if any changes are made. The frequency settings on the ...
1. A ceiling fan is an environmentally smart choice to cool as well as to help warm your home or office. Adjust your hvac thermostat during fan use to save additional energy and money on your air conditioning and heating utility bills. You should see a significant reduction in both your heating and ...
Fan will not start 1. Check that the electricity has been turned on at the circuit breaker which had probably been turned off during installation. 2. Turn off the electricity. Check all connections in the wiring of the fan at the ceiling and make sure it follows the wiring instructions outlined in t...
