Quorum monticello Installation Instructions Manual - page 7
1. Make sure the wiring is safely inside the
outlet box as instructed in Step 5 -
Electrical Connections. To install the
canopy, slide the canopy up to hanger
bracket and place the key hole on the
canopy over the screw on the hanger
bracket, turn canopy until it locks in place
at the narrow section of the key holes. (Fig.
10) Align the circular hole on canopy with
the remaining hole on the hanger bracket,
secure by tightening the two set screws, lift
canopy cover and attach by turning
clockwise. Note: Adjust the canopy screws
as necessary until the canopy and canopy
cover are snug. (Fig. 10)
2. Blade Assembly & Installation (Fig. 11)
Using the supplied blade arm screws, attach
the blades to the blade arms. In some cases
the fiber washer is permanently fixed to the
screw head. Ensure all screws are used for
each blade. Next attach the blades to the
motor assembly using the supplied screws.
DO NOT bend the blade arms when
installing the blades.
3. Attaching the Control Cup
Attach the control cup plate to the flange of
the motor by using the three screws
provided that are pre-installed on the flange.
(Fig. 12)
Snap together the cannon plug, attach the
control cup to the control cup plate with the
three screws provided. (Fig. 13)
A certain amount of wobble may be
considered normal, especially if the fan is
on a downrod long than 12".
6. COMPLETING
THE
INSTALLATION
Fig. 11
Fig. 12
Screws
Fiber
washers
Screws
Blades
Blade arms
Screws
Screws
Control
cup plate
Fiange
Control cup
Cannon plug
Cannon plug
Control cup plate
Fig. 13
Fig. 10
Outlet box
Hanger
bracket
Canopy
Canopy cover
Screws
Screws