QWERT K01+B User Manual - Sleep And Wake Up
power and lengthen standby time. You can click the backlit
LED button to turn the LED on. Users can turn on the LED
in dark environment for better operation.
Sleep and Wake Up
Sleep mode is supported, to save power and lengthen
standby time. If there is no operation more than 3 minutes,
the device will enter sleep mode, with Backlit LED off, RF
indicator on.
In sleep mode, one random click on the keys can wake up
the device.
Turn off the Device after Use
After use, push the Power Switch to OFF position to turn it
off. 2.4G receiver should be plugged out and placed back
to the receiver chamber for future use.
Charging the Battery
This device adopts built-in Polymer Lithium-ion battery.
Please use the cables and chargers approved by my
company.
Note: For initial operation, the battery should be fully
charged.
Use the portable charger:
1. Connect the charger to the device.
2. Connect the charger to the power supply or connect
the charging cable to computer USB port.
3. After about 1 hour (if the power is exhausted, longer
time is required), upper left charging indicator will be on.
When the charging is finished, plug out the charger or
disconnect USB connection to the computer, and remove
the charging cable from the device.
Note: You can use the device when charging, but charging
time will be extended.
When the power is low, the low voltage indicator will warn.