R For Rabbit Jumping Jack Manual - Slackening The Harness
7
Slackening the harness
The harness is slackened by pressing the adjuster
(under the adjuster cover) on the front of the seat.
Press down the adjuster as you grip the two shoulder
straps with your another hand. Pull the shoulder straps
towards you to loosen the harness.
How to adjust the headrest
Removing and store the harness
1) Removing the harness buckle
Open the harness buckle (press the red release button).
Reclining the child seat backwards
Push T bar, with which the harness buckle is fixed to the seat shell, on its side upwards
through the belt slot. Take out the buckle and save it.
2) Store harness straps out of occupant area
Loosen the harness straps. Pull buckle tongues out through the vehicle belt slots in the
backrest. Secure the buckle tongues with webbing ties located in both sides of back cover.
Install or release the back rest
Release
Push it backwards out to the base
Install
Make the two connector into the two base holes, then make it stand upright.
Pic.12
The adjustment of harness straps and head rest
Tightening the harness
Pull the shoulder straps upwards to remove the slack from
the lap sections of the harness then pull the adjuster strap
until the harness is fully tightened.
The harness should be adjusted as tightly as possible
without causing discomfort to your child.
A loose harness can be dangerous.
Check the harness adjuster and tighten each time the
child is placed in the seat.