R.M. Young 06206 Instructions Manual - page 2
Page 1
06206-90(I)
MODEL 06206
WIND TRACKER
SPECIFICATIONS
Size:
144 mm (5.65 in) x 144 mm (5.65 in) x 36 mm (1.4 in)
Panel Cutout:
138 mm (5.43 in) x 138 mm (5.43 in)
Sensors:
Wind Monitor-MA (05), Wind Monitor (05),
Wind Monitor HD (Hd), Wind Monitor-SE (SEr),
Ultrasonic Anemometer (SEr), Wind Monitor-JR
(04), Wind Sentry (03)
Accuracy:
±0.6% Full Scale
NMEA Serial Input & Output:
$WIMWV, ddd, R, sss, u, A*c
ddd wind direction in degrees
sss wind speed (ss.s for m/s)
u units (N knots, K km/hr, M m/s, S statute mph)
c NMEA checksum
Other inputs:
4-20 mA (0-360 deg, Ldi 0-50 m/s, Ld2 0-100 m/s)
Other outputs: 0-5 VDC = 0-360° or 0-540°
0-5 VDC = 0-100 m/s
Alarm Relays:
Normally Open contacts for WS and WD Contact
rating 24 VAC or 30 VDC maximum 5A resistive,
2A inductive maximum
Input Power:
12-30 VDC, 3.5 W
Weight:
1.0 lb (0.45 kg) without AC adapter
INTRODUCTION
The YOUNG Model 06206 Wind Tracker is a compact wind speed
and direction display with advanced features such as relative wind
angle and NMEA serial I/O making it suitable for shipboard use.
FEATURES
• 3-digit wind speed display
• 3-digit maximum wind speed or wind direction display
• Multi-color wind direction display with variability
• Wind speed and direction alarms with delay
• RS-485/NMEA serial connections
• Calibrated 0-5 VDC outputs
• Display brightness control
• Compatible with YOUNG wind sensors & 4-20mA inputs
PRECAUTIONS
• INDOOR USE ONLY!
(Unless placed in approved enclosure)
• Operating temperature range:
0-50°C (32-122°F), 0-95% RH
• Use only recommended power sources.
(12-30 VDC, 3.5 W )
• Disconnect power when connecting or servicing
• Alarm contact rating 24 VAC/30 VDC,
(5 A resistive, 2 A inductive maximum)
MOUNTING AND START-UP
1. For best visibility, place the Wind Tracker in a location free of
direct sunlight. Mount it using the attached bracket or remove
bracket for flush mounting to a bulkhead or panel cutout. Panel
cutout dimensions are given in the specifications. An optional
rack mounting panel (Model 06280) and protective enclosure
(Model 06260) are available from your YOUNG supplier.
2. Connect cables to terminals according to wiring diagram.
IMPORTANT NOTE! Please observe correct position of back
panel Input Selector Switch according to wiring diagram.
3. Connect GND terminal to suitable earth ground.
4. Insert power supply plug into power jack, plug power supply into
a suitable AC wall outlet or connect to suitable 12 to 30 VDC
power source to terminals.
IMPORTANT NOTE! Do not connect more than one power
source to the Wind Tracker at the same time.
5. When power is applied, the Wind Tracker will display firmware
version number then begin to display wind information as follows:
•
Wind speed
•
Wind speed units
•
Maximum wind speed or direction degrees
•
Wind direction (single orange indicator)
•
Direction variability (green indicators)
•
Alarm status indicators (if selected)
•
Wind speed & direction averaging indicator (if selected)
6. Observe display to confirm proper operation.