R.P.S. Corporation 200 Operator's Manual - Page 19
PAGE 19
Problem
Poor dust control.
Poor burnishing quality.
Burnishing scrub deck noisy.
Rear tires noisy.
Poor traction.
Short run time.
Cause
Main vacuum hose disconnected.
Burnishing deck hose disconnected.
Burnishing deck hose clogged.
Damaged main vacuum hose.
Damaged burnishing deck hose.
Filter clogged.
Filter door not closed tightly.
Filter door gasket faulty.
Filter full.
Torn shroud curtain.
Faulty vacuum Motor.
Battery charge is low.
Burnishing pads worn out.
Debris stuck to burnishing pad.
Torn burnishing pad.
Faulty disk pad motor.
Battery charge is low.
Missing burnishing pad.
Burnishing pad worn out.
Torn curtain hitting burnishing disks.
Damaged shroud.
Bearings dry.
Faulty hubs.
Excessive burnishing pad.
Pressure.
Worn drive tire.
Batteries run down.
Batteries still down.
Batteries low on water.
Batteries over cycled.
Solution
Reconnect hose.
Reconnect hose.
Remove debris.
Contact local servicing dealer.
Contact local servicing dealer.
Clean out filters.
Adjust screw on door clamp to
tighten seal.
Contact local servicing dealer.
Remove debris.
Contact local servicing dealer.
Contact local servicing dealer.
Charge batteries overnight.
Replace pads.
Remove debris.
Replace pads.
Contact local servicing dealer.
Charge batteries overnight.
Replace pads.
Replace pads.
Contact local servicing dealer.
Fix or replace shroud.
Grease bearings.
Contact local servicing dealer.
Reduce pressure with switch.
Contact local servicing dealer.
Charge batteries twice
Contact local servicing dealer.
Fill with distilled water to 3/4" above
the lead plates.
Contact local servicing dealer.
Trouble Shooting