R-Tech I-MIG160 MIG Operation Instructions Manual - Connections For Imig 160

Connections for IMIG 160 

Setup machine as per two diagrams below: 

Fig 1                                                      Fig 2   

1. Earth / Workpiece connector  Connect the earth lead (negative -)  to this connector.  

Insert male connector into socket and twist clockwise until tight.  Secure other end of 

earth lead to Workpiece via the earth clamp.   

2. Euro torch connector  Connect Euro type MIG torch to euro torch connector, align torch 

connector to machine connector and then turn retaining ring clockwise to secure.   

Ensure torch is secured tightly to avoid weld power problems   To avoid electric shock 

keep the MIG torch in good condition and replace if any of the insulation is damaged.   

3. Mains input cable  Fit required plug as per your electrical installation    

4. Gas inlet connection  Connect gas hose to rear of machine and then to regulator on gas 

bottle. Ensure all connections are tight to ensure no loss of gas.  Make sure gas bottle is 

secured to machine securely using supplied chain to avoid injury.   

5. On/Off Power Switch  This turns the IMIG 160 MIG Welder on and off. 

6, Gas(+)/no gas(-) plug:  gas style connect with “+”socket and no gas style connect with “-

“socket. 

7, Spool gun socket: When use spool gun function, connect spool gun control plug(7pins) 

with this socket and spool gun main cable connect with euro torch socket.