RAB FFLED39 Installation Instructions

FFLED INSTALLATION INSTRUCTIONS

Thank you for buying RAB lighting fixtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments. 

Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE.

RAB fixtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper grounding is 

required for safety. For fixtures weighing more than 10 lbs - Do not mount to an outlet cover unless a separate splice box is used. 

THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION CODE BY A PERSON FAMILIAR WITH 

THE CONSTRUCTION AND OPERATION OF THE PRODUCT AND THE HAZARDS INVOLVED.

WARNING: Make certain power is OFF before installing or maintaining fixture. No user serviceable parts inside.

ARM MOUNTING

1.  Seal arm thread using teflon tape or silicone sealant.

2.  Secure the LED Flood to a 1/2” NPS hole in a junction box 

or landscape post. Heavy duty XC1 cover provided.

3.  Plug all unused holes and seal threads with silicone.

4.  The swivel arm on the LED Flood allows 180º of vertical 

aiming adjustment depending on mounting location.

SLIPFITTER MOUNTING

1.  The slipfitter mounting fits a 2 3/8” O.D. Tenon. Place the 

slipfitter over the Tenon and secure the fixture with the 

two Set Screws on the side of the slipfitter.

2.  Remove two screws and plug on side of Round Cover 

Plate. Remove the Round Cover Plate and adjust the 

angle of the fixture.

3.  Loosen the Locking Bolt and swivel fixture to desired 

angle.

4.  Tighten the Locking Bolt and re-attach Round Cover 

Plate.

TRUNNION MOUNTING

CAUTION: UL and C-UL listed or CSA certified liquid tight 

cord grip suitable for use with three conductor type 

STW flexible cord shall be used for connection to a wet 

location outlet box provided by others.

To adjust the angle of the fixture using the trunnion:

1.  Loosen the Pivot Bolts & angle locking screw.

2.  Adjust fixture to desired angle.

3.  Tighten Pivot Bolts & angle locking screw.

Locking 

Bolt

Tenon

Set Screws

Round 

Cover 

Plate

Pivot Bolts

FFLED Arm

FFLED Trunnion

FFLED Slipfitter

CLEANING & MAINTENANCE

CAUTION: Be sure fixture temperature is cool enough 

to touch. Do not clean or maintain while fixture is 

energized.

1.  Clean glass lens with non-abrasive glass cleaning 

solution.

2.  Do not open the fixture to clean the LED. Do not touch 

the LED.

TROUBLESHOOTING 

1.  Check that the line voltage at the fixture is correct.  Refer 

to wiring directions.

2.  Is the fixture grounded properly?

3.  Is the photocell, if used, functioning properly?