RAB Lighting MEGAFLOOD Installation Instructions

MEGAFLOOD

TM

 INSTALLATION INSTRUCTIONS 

®

Page 1

SLIPFITTER MOUNTING

1. The slipfi tter fi ts a 2 3/8” O.D. tenon.Place the 

slipfi tter over the tenon and secure with the (2) Set 

Screws on the side of the slipfi tter.

2.  To adjust the angle of the fi xture:

a.  Remove (2) Cover Plate Screws and the 

Round Cover Plate.

b.  Hold the top of the fi xture, loosen the 

Locking Bolt and swivel the fi xture.

c.  Tighten the Locking Bolt and re-attach the 

Round Cover Plate.

IMPORTANT

READ CAREFULLY BEFORE INSTALLING FIXTURE. RETAIN THESE INSTRUCTIONS FOR FUTURE REFERENCE

.

RAB fi xtures must be wired in accordance with the National Electrical Code and all applicable local codes. Proper 

grounding is required for safety. This product must be installed in accordance with the applicable installation code by a 

person familiar with the construction and operation of the product and the hazards involved.

WARNING: 

Make certain power is OFF before installing or maintaining fi xture.

Thank you for buying RAB lighting 

fi xtures. Our aim is to design the 

best quality products to get the job 

done right.  We’d like to hear your 

comments. Call the Marketing 

Department at 888-RAB-1000, or 

email: marketing@rabweb.com

TRUNNION MOUNTING

1. Mount fl oodlight to suitable fl at surface with adequate  

hardware for that surface.

2.  To adjust the angle of the fi xture:

a.  Hold top of fi xture, loosen (2) Trunnion 

Bolts and the Positioning  Screw.

b.  Swivel the fi xture until positioning screw is in 

one of the Positioning Holes.

c.  Tighten the Trunnion Bolts and the 

Positioning Screw.

Locking 

Bolt

Set Screws

Round Cover 

Plate

Cover Plate 

Screws

Trunnion 

Bolts

Positioning 

Holes

Positioning 

Screw

2.5”

3.5”

.Ø 0.532”

5.2”

2.53”

Ø 0.80”