RAB Lighting WPLED 10 Installation Instructions - Troubleshooting
WPLED 10W INSTALLATION INSTRUCTIONS
Thank you for buying RAB lighting fi xtures. Our goal is to design the best quality products to get the job done right. We’d like to hear your comments.
Call the Marketing Department at 888-RAB-1000 or email: marketing@rabweb.com
®
TROUBLESHOOTING
1. Check that the line voltage at fi xture is correct. Refer to
wiring directions.
2. Is the fi xture is grounded properly?
3. Be sure the photocell, if used, is functioning properly.
CLEANING & MAINTENANCE
CAUTION: Be sure fi xture temperature is cool enough
to touch. Do not clean or maintain while fi xture is
energized.
1. Clean glass lens with non-abrasive glass cleaning
solution.
2. Do not open fi xture to clean the LED. Do not touch the
LED.
ON-OFF WIRING
Universal voltage driver permits operation at 120V to
277VAC, 50 or 60Hz except fi xtures factory ordered with a
120V photocell (/PC) and 277V photocell (/PC2). For Junction
Box Mount, feed wires through silicone wiring plug into the
junction box.
1. Connect the black fi xture lead to the (+) LINE supply lead.
2. Connect the white fi xture lead to the (-) COMMON supply
lead.
3. Connect the bare copper Ground wire from fi xture to
supply ground.
JUNCTION BOX
1. The Junction box has (4) conduit entry points on the
center of each side and (1) in the center back.
2. Mounting Points are dimensioned below.
PATENTS: US: pat. D634,878, CN: ZL201030679778.2
4 3/4”
2 3/16”
3 1/2”
1 1/8”
1 1/8”
Mounting Points
Note: These instructions do not cover all details or variations
in equipment nor do they provide for every possible situation
during installation, operation or maintenance.
LIGHT
FIXTURE
(+)LINE
BLACK
(-)COMMON
WHITE
GROUND
GROUND
WPLED10-IN-0715
Easy Installation & Product Help
Tech Help Line
Call our experts 888 RAB-1000
©2015 RAB LIGHTING Inc.
Northvale, New Jersey 07647 USA
rabweb.com
Visit our website for product info
Answered promptly sales@rabweb.com
PHOTOCELL INSTALLATION
Photocell may be installed in the fi eld. Apply weatherproof
silicone sealant to all plugs and unused conduit entries.
1. Remove close up plug on top of the wall mounting box.
2. Install photocell and wire as per diagram.
3. Use photocell rated for your supply voltage.
“COM”
PHOTOCELL
WP2FC
LIGHT
FIXTURE
BLACK
WHITE
PHOTOCELL