RaceAmerica 6450D Owner's Manual - page 7
RaceAmerica Large Digital Display
7
Scoreboard Mounting
Mounting the scoreboard with posts at each end secured to horizontal
straps across the back. 3/8-16 bolts go into PEM nuts secured to the back
of the display.
Figure 2 - Hanging/Mounting options
segment of all five digits, one segment at a time
including the colon or decimal point which exist
to the right of each digit except the right-most
digit. The self-test continues by sequentially
illuminating each segment until all segments,
colons, and decimal points are on. The self-test
continues by drawing a square frame by sliding a
small square from left to right, then down and right
to left. The square then collapses and the revision
level of the code running in the microprocessor is
displayed. When the internal self-test and external
visual test is complete, [rEAdy ] scrolls in from
left to right and blanks out. The display is now
ready for use.
NOTE: IF SWITCH NUMBER 1 ON THE
LEFT BANK IS SET TO THE ‘OFF’ POSITION
DURING THE POWER-UP SELF-TEST, THE
DISPLAY WILL CONTINUOUSLY LOOP ON
THE SELF-TEST UNTIL SWITCH NUMBER 1
IS SET TO THE ‘ON’ POSITION.