Racelogic DAC01 User Manual - Configuring The Dac01
DAC01 MANUAL
Page | 5
22 May 2014
Configuring the DAC01
Hardware connection
Configuration of the DAC01 is performed using Racelogic Config software. Using the supplied RLCAB001 cable, connect
the serial port on the DAC01 to the computers 9 way D serial port – this can be done via a serial > USB converter if
required.
Software connection
Use the drop down list to select the correct COM port that the
speed sensor is connected to. Click the connect button to enter the
DAC01 setup screen.
General
1. Connection - Selected com port, refresh and disconnect buttons.
2. Load/Save - Load/Save settings from/into a Racelogic settings file (.RSF). This allows setups to be kept for
future use.
3. Language - Select an operating language.
4. Write to unit - After making changes to setup, the write to unit button must be selected to upload settings.
5. Unit Information – Serial number and installed firmware version of connected unit.
3
4
2
1
5
4
4