Racelogic VB2SX User Manual - page 9
VB2SX User Guide
Page 9 of 28
SETTINGS
-
GPS MENU
DYNAMIC MODE
DGPS MODE
KALMAN FILTER
BACK
Press’■’ and then the ‘◄’ and
‘►’ buttons to select the
required dynamics.
HIGH DYNAMICS
Essential for brake testing and
lane changing manoeuvres.
NORMAL
Select this for standard testing
–
speed, distance, etc.
LOW DYNAMICS
Select this for route mapping
and similar tests where the level
of dynamic response is not
important.
Press
’■’ and then the ‘◄’ and
‘►’ buttons to select the DGPS
settings.
OFF
No DGPS applied
– standard
position accuracy 3m CEP
WAAS
– position accuracy 1.8m
CEP
40CM
– position accuracy
40CM*
20CM
– position accuracy
20CM*
Press’■’ and then the ‘◄’ and
‘►’ buttons to set Kalmann filter
options.
POSITION LEVEL
Smoothes the positional data
VELOCITY LEVEL
Smoothes the velocity data
Press’■’ to return to the GPS
menu
*Note: These accuracies are only achievable in conjunction with a DGPS base station
OUTPUTS MENU (Channel 1 and 2)
DIGITAL 1
DIGITAL 2
ANALOGUE 1
ANALOGUE 2
BACK
Press’■’ and then the ‘◄’ and
‘►’ buttons to select output
conditions for digital output 1
OUTPUT:
PULSES PER METRE (velocity)
MAX VELOCITY (velocity)
MAX VALUE (Lat ACC & Long
ACC)
MAX FREQUENCY (Lat ACC &
Long ACC)
TEST
BACK
Press’■’ and then the ‘◄’ and
‘►’ buttons to select output
conditions for digital output 2
OUTPUT:
PULSES PER METRE (velocity)
MAX VELOCITY (velocity)
MAX VALUE (Lat ACC & Long
ACC)
MAX FREQUENCY (Lat ACC &
Long ACC)
TEST
BACK
Press’■’ and then the ‘◄’ and
‘►’ buttons to select output
conditions for analogue output 1
OUTPUT:
VALUE @ +5V
VALUE @0V (Velocity)
VALUE @ -5V (Lat ACC & Long
ACC)
TEST
BACK
Press’■’ and then the ‘◄’ and
‘►’ buttons to select output
conditions for analogue output 2
OUTPUT:
VALUE @ +5V
VALUE @0V (Velocity)
VALUE @ -5V (Lat ACC & Long
ACC)
TEST
BACK
Press’■’ to return to the main
menu