Summary of MBK-E Series
Page 2: Mbk-E Series User'S Manual
1 © copyright para systems, inc., 2003 mbk-e series user's manual 1. Introduction 2 2. Controls and indicators 5 3. Installation 7 4. Operation 9 5. Troubleshooting 11 6. Replacing the battery 12 7. Obtaining service 15 8. Specifications 16 9. Configurable parameters & settings 17 10. Limited produc...
Page 3: Save These Instructions !
2 important safety instructions save these instructions ! English thank you for purchasing a minuteman power protection product. It has been designed and manufactured to provide many years of trouble free service. Please read this manual before installing your mbk-e series ups, models mbk550e, mbk75...
Page 4: Caution!
3 caution! To reduce the risk of electrical shock in conditions where the load equipment grounding cannot be verified, disconnect the ups from the ac wall outlet before installing a computer interface cable. Reconnect the power cord only after all signaling connections are made. Caution! Connect the...
Page 5: Receiving Inspection
4 english para systems life support policy as a general policy, para systems inc. (para systems) does not recommend the use of any of its products in life support applications where failure or mal- function of the para systems product can be reasonably expected to cause failure of the life support d...
Page 6
5 on-line on-battery boost english on-line/on-battery/boost led overload led weak/bad battery led on/off/test button fault led press and release the on/off/test button after 1 beep to turn the ups on or off (see section 4). The on-line/on-battery and boost (green) led illuminates in a steady state w...
Page 7: Rear Panel
6 rear panel english 5 4 3 2 1 9 8 6 7 1. The information/rating label. 2. The battery backup and surge output power receptacles are nema 5-15r type. 3. The usb communications interface port is for ups monitoring and control. 4. The surge only output power receptacles are nema 5-15r type. 5. The dip...
Page 8: Installation Placement
7 installation placement the mbk-e series is intended to be install in a temperature controlled environ- ment that is free of conductive contaminants. Select a location which will pro- vide good air circulation for the ups at all times. Avoid locations near heating devices, water or excessive humidi...
Page 9: Warning!
8 english do not plug power strips or surge protection devices into the ”battery backup” receptacles on the ups. Plugging power strips or surge protection devices into the “battery backup” receptacles may cause internal damage to the ups, the power strip, or the surge protection device. Warning! Cha...
Page 10: Turning The Unit On/off
9 english turning the unit on/off on / off / test button self test press and release the on/off/test button after one beep to turn the ups on and supply power to the load. The load is immediately powered while the ups runs a two-second self test. Press and release the on/off/test button after one be...
Page 11
10 english communications port the mbk-e series comes standard with a usb communication port. Note: see the sentryii cd for the power monitoring software installation. See the usb driver cd for the usb installation. Alarms on battery when the ups is operating on the batteries, the on-battery led wil...
Page 12
11 english possible cause symptom what to do press and release the on/off/ test button to start ups on/off/test button not pushed ups will not turn on reset circuit breaker by pressing the plunger back in. If the ac circuit breaker trips after ups starts up, reduce the load on the ups ups operates i...
Page 13: Replacing The Battery
12 english replacing the battery the mbk-e series ups has an easy to replace hot-swappable batteries. Please read all of the warning and cautions before attempting to service the batteries. Note: if there is a power interruption while replacing the hot-swappable batteries, with the ups on, the load ...
Page 14
13 english battery replacement procedure please read the cautions and warnings before attempting to replace the batteries hot-swappable batteries mean that the batteries can be replaced without powering down the whole ups system. Note: if there is a power interruption while replacing the hot-swappab...
Page 15
14 english 9. Disconnect the positive (red) wire from the battery positve terminal. 10. Disconnect the battery negative (black) wire from the battery negative terminal. Note: use caution, do not touch the battery positive wire to the battery negative wire. 11. Remove the battery bracket retaining sc...
Page 16: If The Ups Requires Service
15 english if the ups requires service 1.Use the troubleshooting section to eliminate obvious causes. 2.Verify there are no circuit breakers tripped. A tripped circuit breaker is the most common problem. 3.Call your dealer for assistance. If you cannot reach your dealer, or if they cannot resolve th...
Page 17
16 english default 120vac (user selectable at 120/127vac) 2-4 years, depending on discharge cycles and ambient temp 550va/330w 750va/450w 500 j 0 ns (instantaneous) normal mode; normal and common mode emi/rfi suppression 1-12v7ah 2-12v7ah audible noise at 1 m (3 ft.) electromagnetic immunity runtime...
Page 18
17 english (these items may require optional software or hardware) function factory default description user choices set inverter output voltage set audible alarm state enable/ disable auto restart battery life in days battery install date ups id mbk-e date of manufacture 1826 enabled enabled 120vac...
Page 19
18 english para systems inc. (para systems) warrants this equipment, when properly applied and operated within specified conditions, against faulty materials (ex- cluding batteries) or workmanship for a period of three years from the date of purchase. Para systems inc. (para systems) warrants the ba...
Page 20: Limited Product Warranty
19 english except as provided above, in no event will para systems be liable for direct, indirect, special, incidental, or consequen- tial damages arising out of the use of this product, even if advised of the possibility of such damage. Specifically, para sys- tems is not liable for any costs, such...
Page 21: Declaration of Conformity
20 declaration of conformity application of council directive(s): 89/336/eec, 73/23/eec standard(s) to which conformity is declared: en50091-1-1, en50091-2 manufacturer’s name: para systems, inc. (minuteman ups) manufacturer’s address: 1455 lemay drive carrollton, texas 75007 usa type of equipment: ...
Page 22
21 notes: english.
Page 23
22 english notes:.
Page 24
23 page do not print.