Summary of Movin Cool PC 7
Page 1
SecciÓn en espaÑol section en franÇais available at www.Movincool.Com.
Page 4
Congratulations on purchasing the movincool portable air conditioner. This manual explains how to install and operate the movincool pc 7 portable air conditioning unit. Please read this operation manual thoroughly to familiarize yourself with the features of the unit and to ensure years of reliable ...
Page 5: Mobile Air Conditioner
Introduction mobile air conditioner other air conditioning solutions are recommended when the ambient temperature is either below 63 °f (17°c) or above 88° f (31°c). Note: when the ambient temperature is high, condensation may occur to the unit. Attention there might be some water remained in the bo...
Page 6
Unit description and function front air outlet left/right air direction control tab caster up/down air louver handle note: open the up/down air louver to the highest position before the unit is turned on. Control panel left/right air swinging fins back air-return grill power cord holders base stoppe...
Page 7
Unit description and function (cont.) timer button press this button to set the time for switch-on, switch-off timer or to delete the timer. Fan speed button press this button to choose high, medium or low speed of air delivery. Temp button press these buttons to change the set point temperature. Mo...
Page 8
Operaton and indicators of remote control remote control install the supplied batteries (type aaa 1.5v) to the remote controller. This button is used to select the cooling, drying,fanning mode of operation. This button is used to set the switch-on or switch-off time. Use together with the “hour” but...
Page 9
Operation and indicators of remote control (cont.) present time setting procedure when batteries are inserted,time is automatically set to 00:00. Set the present time as follows. Example:set time to 10:30 continuously press the hour button for 2 seconds . The time indicator is blinking and can set t...
Page 10
The operating ranges for cooling operation and dehumidifying are 63ºf-88ºf(17ºc-31ºc). Dehumidifying and cooling operation power source warning the ac outlet (115 vac,single phase,60hz) must be rated at 15a or higher. The ac socket must be firm and reliable. Do not connect the unit to a multiple soc...
Page 11: Auto Swing Function
To set time to start the unit with the unit off (stand by power), press timer button, the lcd window shows" , repeatedly press the hour button, set the time to start as you like. The setting range is 1-12 hours. To set time to stop the unit with the unit operating, press timer button, the lcd window...
Page 12
Maintenance/service pull the power plug out of the socket before cleaning. Make sure there is no power to the unit before maintenance or repair to prevent accident caused by electrical shock. Cleaning of air filter if the air filter is blocked with a lot of dust, the air flow volume will reduce. Cle...
Page 13: Safety Cautions
Maintenance/service (cont.) after operational seasons 1. Turn off the unit, and disconnet the power source. 2. Make proper maintenance to the air filter and other parts. 3. Open the base stopper to drain out the condensed water in the condensate pan, then operate the unit in fan mode for half a day ...
Page 14: Self-Diagnosis Function
Troubleshooting check the following items before calling your movincool reseller or a qualified technician. Condition check area remedy unit does not operate at all. Is there power? Is it plugged in? Plug into the wall socket. Is the fuse or circuit breaker switch turned off? Change the fuse or turn...
Page 15: Mounting Through The Window
1 installation selection of installation location put the unit on a flat location where the air outlets are not covered up, place the unit no less than 20 inch (500 mm) away from a wall or other obstacle. Power cord holder installation install the supplied power cord holders with the supplied two se...
Page 16
Installation (cont.) mounting through the wall 1) shrink the exhaust air duct. 2) insert the duct into the square adapter. Rotate the duct (2-3 rounds). 3) insert the other end of the duct into the window exhaust adapter 1. Rotate the duct (2-3 rounds). Attach the window exhaust adapter 2. 4) fix th...
Page 17
Installation (cont.) if the exhaust air duct requires bending, see figures below. Incorrect duct mounting fig. 4 (bending the duct sharply can easily cause malfunction.).
Page 18
Installation (cont.) window slider kit installation the window slider kit is designed to fit most standard "vertical" and "horizontal" widow applications.However, it may be necessary for you to improve/modify some aspects of the installation procedures for certain types of windows. Please refer to f...
Page 19
Installation (cont.) i nstallation accessories fig. 7 description exhaust air duct with adapters...........4/set stretches from 19-1/2" (500 mm) up to 78-3/4" (2000 mm) adjustable window slider kit.........................2/set stretches from 26-5/8" (675 mm) up to 48-3/8" (1230 mm) power cord holde...
Page 20
Lcdi power cord the lcdi device is a non-serviceable part. Attempting to open the device may expose the user to hazardous electric shock, and voids any warranties and performance claims. Manufacturer’s liability is limited to the replacement of the device. 1. Read manual for proper use and handling ...
Page 21
Denso sales california, inc.( “denso”) warrants its movincool products only to the extent stated in its official written warranties. Unless otherwise specifically provided in writing by denso, denso warrants to end-user that the products shall be free of defects in materials or workmanship and will ...
Page 22
P/n: 484007- 3290en first lssue: march 2010 www.Movincool.Com long beach ca,90810 denso sales california, inc..