RACOM PROFI MW160 Operating Manual

Manual is about: Wideband modems – PROFI MW160

Summary of PROFI MW160

  • Page 1

    Operating manual . Wideband modems – profi mw160 . Version 1.5 3/31/2014 www.Racom.Eu racom s.R.O. • mirova 1283 • 592 31 nove mesto na morave • czech republic tel.: +420 565 659 511 • fax: +420 565 659 512 • e-mail: racom@racom.Eu.

  • Page 3

    Table of contents introduction .......................................................................................................................................... 5 1. Radio modem mw160 ..............................................................................................................

  • Page 4

    List of tables 3.1. Table of data connector rs232 connections ................................................................................ 9 3.2. Table of data connector rs422 connections .............................................................................. 10 3.3. Table for distinguish...

  • Page 5: Introduction

    Introduction this operator manual serves as the primary document for familiarising users with the parameters of the radio modem mw160, its properties, modifications and with the parameters of connecting parts. This controller is part of the morse system, is fully compatible with other modems, and be...

  • Page 6: 1. Radio Modem Mw160

    1. Radio modem mw160 mw160 is conceptually new radio modems designed for transmitting data in the vhf and uhf bands. The radio modem uses 2-state gmsk modulation providing for a maximum signalling rate of 133 kbit/s. The radio modem is of modular design with one to four standard rs232 ports (an rs42...

  • Page 7

    2. Description of radiomodem mw160 2.1. Radio part the architecture of mw160 radio modems resolves most of the requirements placed on a top quality user friendly radio modem with a very short switching time between receiving and transmitting. Frequency synthesis enables operation on any random chann...

  • Page 8

    Important caution! Danger of explosion upon replacing the incorrect type of battery. Follow the manufacturers instructions for handling used batteries. Wideband modems – profi mw160 – © racom s.R.O. 8 description of radiomodem mw160

  • Page 9: 3. Connectors

    3. Connectors 3.1. Antenna the cable for connecting the antenna is fitted with an sma type connector. Use a connector of the corresponding type and impedance as its mate. We recommend using an rg158. Important the radio modem cannot be connected to the power supply without the antenna connected (or ...

  • Page 10

    B) table of data connector rs422 connections tab. 3.2: table of data connector rs422 connections dsub9f pin screw terminals rs422 signal 7 1 txd- 3 2 txd+ 8 3 rxd- 2 4 rxd+ 5 5 gnd c) connection diagram of data cable rs485 when you are connecting rs485, your “a” has to be connected to txd+ and rxd+ ...

  • Page 11

    3.2.3. Labelling of scc terminals txd rxd dte plc txd rxd red led dce morse router green led fig. 3.3: labelling of serial interface terminals the scc ports of the router are dce type devices. Based on standards the receiver terminal rxd of the connected dte device is connected to the transmitting t...

  • Page 12

    Fig. 3.4: rj-45f tab. 3.4: table of ethernet to cable connector connections crossed cable direct cable signal pin white - green white - orange tx+ 1 green orange tx- 2 white - orange white - green rx+ 3 blue blue — 4 white - blue white - blue — 5 orange green rx- 6 white - brown white - brown — 7 br...

  • Page 13

    + + + + + + + + + – – – – – – – – – a out a in d out d in up 1 1 1 1 0 0 0 0 fig. 3.6: description of analog and digital inputs and outputs 3.4.2. Parameters tab. 3.5: table of digital and analog input and output parameters passive – bipolar ssr switch design – voltage for supplying load max. 30 v d...

  • Page 14

    3.5. Gps module a gps module can be positioned in the first or second slot of optional modules, see section section 3.9, “view of radio modem”. (for mg100 only in the first slot.) the second slot is recommended because when using slot 1 you first need to disconnect it in the modem´s service mode, se...

  • Page 15

    Meaning of led colours tab. 3.7: meaning of gps module leds tp – time pulse red st – status (in progress) green the gps is providing the correct data if the red led is flashing to the rhythm of time pulses (typically 1 s). Fig. 3.8: gps modul on 2 nd slot of mr400 modem tab. 3.8: gps module paramete...

  • Page 16

    Terminal pi (power indicator) - if the radio modem is fed from the ms2000 power supply information about supply method from source clamp main pwr off can be lead: fig. 3.9: power connector & information led • level ttl1 or unconnected clamp - network supply • level ttl0 or grounded clamp - battery s...

  • Page 17

    1 2 3 4 5 6 pin 5 pin 3 pin 2 cannon dsub9f rx data tx data gnd fig. 3.11: service cable connector connections 3.9. View of radio modem the only difference in appearance between the radio modem mw160 and the radio modem mr400 is the type designation badge – see the following image. 17 © racom s.R.O....

  • Page 19

    4. Table of technical parameters tab. 4.1: table of technical parameters mw160 mw160: 135–175 mhz frequency range 200 khz channel spacing software in range +3.2 mhz from base frequency means of setting working frequency switching time transmitting/receiving better than -100 dbm receiver sensitivity ...

  • Page 20

    Tab. 4.2: standards complied etsi en 301 489-5 v 1.3.1 emc (electromagnetic compatibility) csn en 60 950:2001 electrical safety un regulation no.10 (ehk no.10) wheeled vehicle usage wideband modems – profi mw160 – © racom s.R.O. 20 table of technical parameters.

  • Page 21

    5. Dimensional diagram and labeling modems dimensional diagram mobile mounting 4×m4 din 35 rail mounting 2×m4 not for p rf power 25 w (type p) 4×m4 only fig. 5.1: mounting dimensions of the radiomodem the modem can be fasten by four screws m4 (for mobile application especially) or by the mounting ra...

  • Page 22

    Digital and analog channels: mw161.0p45c-n-485i-232-e-d22a22 analog i/o line type: optically separated: rs422/485 unused position rs232 rs232 232 ethernet present unused position n 232i 232 232 n 485i 232i n morse components production code radiomodems profi wideband radio channel and case version: ...

  • Page 23: 6. Condition For Mw160

    6. Condition for mw160 6.1. Important warning racom s. R. O. (hereinafter referred to as racom) is the exclusive owner of all rights to this operator manual. All rights reserved. Any duplication of this manual in any way, shape or form, or translation to any other language (without the prior written...

  • Page 24

    Protection for output circuits. If another power supply is used fuses, overcurrent protection or similar protective components should be used. ○ in threshold mode the radio modem is capable of operation at an ambient temperature of up to 70 °c. In such cases the temperature of the surface of the rad...

  • Page 25

    6.4. Country of origin country of origin declaration manufacturer: racom address: mirova 1283, 592 31 nove mesto na morave, czech republic vat no: cz46343423 we, the manufacturer, hereby declare that country of origin of the ray microwave links and its accessories is the czech republic, eu. Nove mes...

  • Page 26

    6.5. Limitations of use the mw160 radio modem has been developed for the frequency range 156 to 164 mhz. Specific fre- quencies are used for each country or region. A radio modem user must keep in mind that this radio device cannot be operated without the permission of the respective local radio spe...

  • Page 27

    Appendix a. Revision history 20014-03-27 revision 1.5 added section section 6.4, “country of origin” 27 © racom s.R.O. – wideband modems – profi mw160 revision history.