Installation and operation manual etx-41 gigabit ethernet layer 1 media converter version 2.0
Etx-41 gigabit ethernet layer 1 media converter version 2.0 installation and operation manual notice this manual contains information that is proprietary to rad data communications ltd. ("rad"). No part of this publication may be reproduced in any form whatsoever without prior written approval by ra...
Limited warranty rad warrants to distributor that the hardware in the etx-41 to be delivered hereunder shall be free of defects in material and workmanship under normal use and service for a period of twelve (12) months following the date of shipment to distributor. If, during the warranty period, a...
Product disposal to facilitate the reuse, recycling and other forms of recovery of waste equipment in protecting the environment, the owner of this rad product is required to refrain from disposing of this product as unsorted municipal waste at the end of its life cycle. Upon termination of the unit...
In some cases, the users may insert their own sfp laser transceivers into the product. Users are alerted that rad cannot be held responsible for any damage that may result if non-compliant transceivers are used. In particular, users are warned to use only agency approved products that comply with th...
The maximum permissible current capability of the branch distribution circuit that supplies power to the product is 16a. The circuit breaker in the building installation should have high breaking capacity and must operate at short-circuit current exceeding 35a. Before connecting the dc supply wires,...
Some selv and non-selv circuits use the same connectors. Use caution when connecting cables. Extra caution should be exercised during thunderstorms. When using shielded or coaxial cables, verify that there is a good ground connection at both ends. The earthing and bonding of the ground connections s...
Fcc-15 user information this equipment has been tested and found to comply with the limits of the class a digital device, pursuant to part 15 of the fcc rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial envir...
Etx-41 ver. 2.0 i contents chapter 1. Introduction 1.1 overview..................................................................................................................... 1-1 application ..........................................................................................................
Table of contents installation and operation manual ii etx-41 ver. 2.0
Etx-41 ver. 2.0 overview 1-1 chapter 1 introduction 1.1 overview etx-41 provides cost-effective utp-to-fiber media conversion for gigabit ethernet services. The etx-41 card has the following options: • etx-41/utp/ge-m, converting between utp and multimode fiber optic cables • etx-41/utp/ge-1, conver...
Chapter 1 introduction installation and operation manual 1-2 overview etx-41 ver. 2.0 features etx-41 modules etx-41 is a media converter that provides transparent conversion of optical and electrical signals for the gigabit ethernet service. The media converter is used to extend the operation dista...
Installation and operation manual chapter 1 introduction etx-41 ver. 2.0 physical description 1-3 • utp to fiber optic. Etx-41 automatically shuts down the fiber optic port if a failure is detected on the utp port. The fiber optic link is re-established when the utp connection is restored. • rx-to-t...
Chapter 1 introduction installation and operation manual 1-4 technical specifications etx-41 ver. 2.0 figure 1-2. Etx-41 modules 1.3 technical specifications utp interface type gigabit ethernet, autonegotiation at 1000 mbps full duplex, mdi/mdix cable type category 5 utp cable length up to 100m (328...
Installation and operation manual chapter 1 introduction etx-41 ver. 2.0 technical specifications 1-5 • on – data is being received at utp interface • off – no data is being received at utp interface fdx (green): • on – utp interface operates in full duplex • off – utp interface operates in half dup...
Chapter 1 introduction installation and operation manual 1-6 technical specifications etx-41 ver. 2.0
Etx-41 ver. 2.0 installing etx-41 modules 2-1 chapter 2 installation and setup this chapter provides installation and configuration instructions for the lrs-1 rack and etx-41 modules. The etx-41 modules contain components sensitive to electrostatic discharge (esd). To prevent esd damage, always hold...
Chapter 2 installation and setup installation and operation manual 2-2 installing etx-41 modules etx-41 ver. 2.0 sw2 on 123 4 figure 2-1. Etx-41 pcb layout to control fault propagation modes: • set section 1, 2 and 3 of the sw2 dip switch according to 2h table 2-1 . Etx-41 modules contain additional...
Installation and operation manual chapter 2 installation and setup etx-41 ver. 2.0 connecting to ethernet equipment 2-3 installing etx-41 modules into the chassis the etx-41 modules can be installed in 16-slot lrs-20 or single-slot lrs-1 chassis. To install an etx-41 module: 1. Insert an etx-41 modu...
Chapter 2 installation and setup installation and operation manual 2-4 connecting the power etx-41 ver. 2.0 2.4 connecting the power to connect lrs-1 to the power source, refer to the appropriate section below, depending on your version of the unit (ac or dc). Before switching on this unit and conne...
24 raoul wallenberg st., tel aviv 69719, israel tel: +972-3-6458181, fax: +972-3-6483331, +972-3-6498250 e-mail: , web site: customer response form rad data communications would like your help in improving its product documentation. Please complete and return this form by mail or by fax or send us a...
Error report type of error(s) incompatibility with product or problem(s): difficulty in understanding text regulatory information (safety, compliance, warnings, etc.) difficulty in finding needed information missing information illogical flow of information style (spelling, grammar, references, etc....
Publication no. 419-200-09/06 2h www.Rad.Com international headquarters: 24 raoul wallenberg street, tel aviv 69719, israel, tel: 972-3-6458181 fax: 972-3-6498250, 972-3-6474436, email: 3h market@rad.Com north america headquarters: 900 corporate drive, mahwah, n.J. 07430, tel: (201) 529-1100 toll fr...