RAD Data Communications FLM-1 Installation And Operation Manual - List of Figures
FLM-1 Installation and Operation Manual
iii
List of Figures
Figure 1-1 Typical Point-to-Point Application................................................................................ 1-2
Figure 1-2 Typical Ring Installation ............................................................................................... 1-2
Figure 1-3 FLM-1 3D View ........................................................................................................... 1-3
Figure 2-1 Strapping Diagram ....................................................................................................... 2-3
Figure 2-2 FLM-1/4W Rear Panel with a Terminal Block Main Link Connector ............................. 2-3
Figure 2-3 FLM-1/4W Rear Panel with an RJ-45 Main Link Connector.......................................... 2-3
Figure 2-4 FLM-1/DF Rear Panel with aDF Main Link Connector................................................. 2-3
Figure 2-5 FLM-1/4W Rear Panel with RJ-45 Main Link and Subchannel Connectors ................... 2-4
Figure 2-6 FLM-1/DF Rear Panel with STA Main Link and RJ-45 Subchannel Connectors ............ 2-4
Figure 2-7 FLM-1/4W Rear Panel with Main Link Terminal Block and RJ-45 Subchannel
Connectors ............................................................................................................................. 2-4
Figure 2-8 Connecting Channel Doubler to an FLM-1 Subchannel for 12 Channel Operation....... 2-5
Figure 2-9 Suggested Connection for Transmitting DTR to DSR Control Signals End-to-End
(DB-25 Connectors) ................................................................................................................ 2-5
Figure 2-10 Suggested Connection for Transmitting RTS to DCD Control Signals End-to-end
(DB-25 Connectors) ................................................................................................................ 2-5
Figure 2-11 Suggested Connection for Transmitting DTR to DSR Control Signals End-to-End
(RJ-45 Connectors).................................................................................................................. 2-6
Figure 2-12 Suggested Connection for Transmitting RTS to DCD Control Signals End-to-end
(RJ-45 Connectors).................................................................................................................. 2-6
Figure 3-1 FLM-1 Front Panel ....................................................................................................... 3-1
List of Tables
Table 1-1 Distortion and Number of Sites for FLM-1 in Ring Application ....................................... 1-3
Table 1-2 Performance in Various Modes of Operation ................................................................. 1-4
Table 3-1 FLM-1 Indicators and Switches ...................................................................................... 3-2
Table 4-1 Fault Isolation and Troubleshooting................................................................................ 4-3