RAD Data Communications SPS-12 Installation and operation manual - Contents
SPS-6, SPS-12
i
Contents
Chapter 1. Introduction
1.1
Overview.....................................................................................................................
1-1
1.2
Technical Specifications...............................................................................................
1-2
Chapter 2. Installation and Setup
2.1
Introduction.................................................................................................................
2-1
2.2
Unpacking...................................................................................................................
2-1
2.3
Site Requirements........................................................................................................
2-1
Power...................................................................................................................................
2-1
Data Channel Connections ...................................................................................................
2-1
Main Links Connections........................................................................................................
2-2
Front and Rear Panel Clearance ............................................................................................
2-2
Ambient Requirements .........................................................................................................
2-2
2.4
Hardware Configuration Information ...........................................................................
2-2
General Information .............................................................................................................
2-2
Internal Jumpers ...................................................................................................................
2-3
INIT-NOR jumper, JP39........................................................................................................
2-3
IR-ETH jumper, J13...............................................................................................................
2-4
IR-ETH jumper, JP44.............................................................................................................
2-4
Interface Board.....................................................................................................................
2-4
Jumper Setting Procedure .....................................................................................................
2-5
2.5
Installation in 19" Racks ...............................................................................................
2-6
Installing the Unit..................................................................................................................
2-6
2.6
Cable Connections ......................................................................................................
2-7
General ................................................................................................................................
2-7
Asynchronous Data Channel Connections .............................................................................
2-7
Synchronous Links Connection .............................................................................................
2-8
Power Connection................................................................................................................
2-8
Chapter 3. Operation
3.1
General .......................................................................................................................
3-1
3.2
Controls, Indicators and Connectors ............................................................................
3-1
Front Panel Controls, Indicators and Connectors ...................................................................
3-1
Rear Panel Controls and Connectors .....................................................................................
3-3
3.3
Operating Instructions .................................................................................................
3-3
General ................................................................................................................................
3-3
Power-On ............................................................................................................................
3-3
Normal Operation ................................................................................................................
3-4
Power-off .............................................................................................................................
3-4
3.4
Upgrading the Software ...............................................................................................
3-4
3.5
What to do in Case of Malfunction ..............................................................................
3-6
Preliminary Checks ...............................................................................................................
3-6
Troubleshooting....................................................................................................................
3-6
Appendix A. Connector Pinouts