RAD E-RAD 950 Quick User Manual - 4. Exportdatatopc
Version 1.0 - June 2017
5
User manual E-RAD BLU
4. ExportdatatoPC
To export the data from the E-RAD BLU to your PC, simply connect the controller to your PC using the
provided data cable (printer cable). Choose “menu” and option 3 – pc transfer and the data exchange can
be controlled from the PC.
The E-RAD data logger software can be downloaded free of charge from
www.eradtorque.com.
5. Movementofthereactionarm
Figure 3
Reaction point
Clockwise
operation
Counter clockwise
operation
WARNING: In use, this tool must be supported at all times in order to prevent unexpected release in the
event of a fastener or component failure!
5.1 Installing the reaction arm
Ensure the reaction arm and retaining ring are installed securely to hold the reaction arm in place. Make
sure the reaction arm is in contact with a solid reaction point before you operate the tool. When the tool
is in operation the reaction arm rotates in the opposite direction to the output square drive and must be
allowed to rest squarely against a solid object or surface adjacent to the bolt to be tightened (Figure 3).
NOTE: Improper reaction will void warranty and can cause premature tool failure.
5.2 Reactie arm height
Ensure the height of the socket is even with the height of the reaction arm as seen below in Figure 4A.
The height of the socket cannot be shorter or higher than the height of the reaction arm as seen below in
Figure 4B and 4C.
Figure 4A
Figure 4B
Figure 4C
✔
✘
✘