RAD Sportz Electric Air Pump & Gauge Instruction Manual - Operating Instructions
To use your air pump :
1. Remove unit from case and plug in the 12V DC cigarette lighter adapter to the
cigarette lighter of your vehicle. Note: some vehicles may have a second 12V port
as well.
2. Turn on your vehicle.
3. Next, attach air hose (with proper tip adapter, depending upon what you need to
inflate) securely to the tire or object to be inflated. Be sure adapter/hose is
fastened securely and that
there are no air leaks.
4. Turn on the compressor by
switching the ON/OFF rocker
switch to ON.
5. Watch the pressure gauge
(Figure 1) to make sure that
you do not over-inflate your
tire or toys...remember:
NEVER EXCEED THE
RECOMMENDED
PRESSURE RATING. OVER-INFLATION CAN RESULT IN TIRE BURSTING OR
EXPLOSION AND SERIOUS INJURY MAY RESULT!
Usual inflation time is approximately 2-3 minutes to reach 30-35 PSI.
6. When the recommended pressure has been achieved, shut the compressor off by
toggling the rocker switch to the OFF position. Remove hose and disconnect the
air pump from the 12V power source.
OPERATING INSTRUCTIONS
4
USING YOUR 12V RAD AIR PUMP
Copyright 2011 DTX International
Figure 1