RAD V- 14 User Manual - page 5
Version 1 - 07-2015
5
User manual V-RAD
WARNING: Keep your hand and body parts clear of the reaction arm and barrel when the tool is in
operation.
WARNING: On the top of the V-RAD there will be a selector switch that will show a picture of a drill bit
on the left side: this is the correct position for the switch. If the switch is moved to the left and a picture
of a hammer is shown on the right, the gun is set im-properly and may cause tool failure, see Figure 6.
WARNING: On the handle of your V-RAD there will be a small button that is used as a trigger locking
mechanism and has been locked out for your safety. Do not try to push this button in and enable the
mechanism it will put the user at risk of injury, see Figure 7.
WARNING: Do not attempt to run the tool with a setting that is not displayed on the torque charge. Do
not operate the V-RAD using the (+) symbol on the numeric dial. Failure to do so may cause the tool to
fail and void your warranty.
3.2 Setting direction of rotation
To switch your V-RAD into forward and reverse, move the switch up and down, see Figure 5.
Up setting
=
Tightening
Down setting
=
Loosening
Central setting
=
Transportation position
Figure 5
Figure 6
Figure 7