1. DL manuals
  2. Rad2Go
  3. Scooter
  4. Mo Rad 1500
  5. Owner's Manual

Rad2Go Mo Rad 1500 Owner's Manual - page 38

Summary of Mo Rad 1500

  • Page 1

    Mo rad 1500 owner’s manual.

  • Page 2

    The handbook the instructions in this handbook are designed to provide a clear and simple guide to use your new vehicle. The handbook contains information regarding maintenance work and periodic checks that should be performed. You will also find instructions for several simple repair jobs you can d...

  • Page 3

    Symbols for the correct use of your new vehicle the symbols on the page are important. They highlight area of the handbook that deserve special attention. The three symbols are distinctive so that information can be quickly located. Personal safety warning failure to observe these instructions will ...

  • Page 4

    General safety rules foreword this manual is an important and integral part of your vehicle. Keep it with your vehicle at all times and when vehicle is resold. If you have any questions any questions about your vehicle, contact rad2go or an authorized rad2go dealer. Rear wheel warning be vary carefu...

  • Page 5

    Precautions general advice warning your safety and that of those around you depends not only on your skills as a rider, but also your knowledge about your motorscooter and about riding safety. Therefore, it is essential that you so not operate your vehicle on public streets until you have received i...

  • Page 6

    Road regulations and use of the motorscooter rules of the road may vary from country to country or state to state. It is essential that you understand in advance the rules of the road of the country or of the state in which your vehicle will be used. Warning this motorscooter has been designed and p...

  • Page 7

    Tampering warning tampering with the noise control system is prohibited. Federal law prohibits the following acts: a) removal or rendering inoperative by any person other then for the purpose of maintenance, repair, or replacement, and devise or element of design incorporated into any new motorscoot...

  • Page 8

    Keys the motorscooter is supplied with two keys (one spare) that serve to start the engine and unlock the saddle compartment. Note keep the duplicate key separate from the motorscooter. 8.

  • Page 9

    The serial numbers are made up of a code stamped into the frame and the engine. Check that the frame number on the vehicle is identical to the number shown in the owner’s handbook. Defacing factory serial numbers is a serious criminal offense and can lead to confiscation of the vehicle or other pena...

  • Page 10

    Starting the engine 1. Place the vehicle on center stand and check that the rear tire is not touching the ground. 2. Keep the throttle closed. 3. Insert the ignition key and turn it to “on”. Stopping the engine when the vehicle is stopped with the engine idling turn the ignition key to “off” (key ca...

  • Page 11

    To ride away: allow the throttle to return to idle, apply the rear brake, and then remove the vehicle from the stand. Get on the vehicle, keeping at least one foot on the ground in order not to lose balance. Before driving, be sure that the review mirrors are correctly adjusted. Caution when the veh...

  • Page 12

    Always use the turn signals any time you intend to change lanes or change direction, and avoid sudden or abrupt turning. Switch off the direction indicators as soon as you have changed directions. Overtake and pass with care, especially in rainy weather. A water cloud created by larger vehicles will...

  • Page 13

    Warning failure to follow these simple recommendations can damage your motorscooter, and lead to an accident, with subsequent serious injury, or even death. The life of your motorscooter, and your enjoyment of it, will be greatly enhanced if you avoid situations in which the motorscooter will be abu...

  • Page 14

    Basic safety rules the instructions below cover normal operation of your motorscooter and must be carefully observed. By following these rules you will enhance your own safety and the safety of others. You will also maximize the life and utility of your motorscooter. Motorscooters obviously do not p...

  • Page 15

    Warning do not ride the motorscooter if the throttle does not automatically return to idle. Contact rad2go service technician who will provide for the necessary repairs. It is very important to your safety that you give full attention to the riding task, watch what you are doing, do not allow yourse...

  • Page 16

    Never race other motorscooters or motorcycles with your motorscooter. Brake with both the front and rear brakes. The use of one brake only for sudden braking may cause the motorscooter to skid or make the rider lose control of the motorscooter itself. Always ride at a safe speed and avoid unnecessar...

  • Page 17

    Additional riding gear in addition to a helmet and eye protection, we also recommend: sturdy boots with non-slip soles to help protect your feet and ankles. Leather gloves to keep your hands warm, and help prevent blisters, cuts, burns, and bruises. A motorscooter riding suit or jacket for comfort a...

  • Page 18

    Load do not overload your motorscooter. Attach luggage or packages as closely as possible to the center of your motorscooter and distribute the load from side to side as evenly as possible, to keep imbalance to a minimum. Remember that loads tend to loosen with riding, so frequently check the securi...

  • Page 19

    Tire repair if a tire is punctured or damaged, you should replace it not repair it. As discussed below, a tire that is repaired, either temporarily or permanently, will have lower speed and performance limits than a new tire. A temporary repair, such as an external tubeless tire plug, may not be saf...

  • Page 20

    Caution when working on the electrical system, pay special attention to the correct connection of wires leading to the electronic ignition unit and observe the polarity and connector color- coding. Modifications or unsuitable repairs of the electrical system can cause malfunctions and represent a se...

  • Page 21

    Storage if the motorscooter is not to be used for prolonged periods, the battery must be charged periodically (when not in use, the battery will discharge over a period of 3 months). If the battery is removed, when you reinstall the battery make sure you connect the positive (+) and negative (-) lea...

  • Page 22

    Technical specification motor power 1500w brake-horsepower 2.012052 bhp battery dc 48v, 40ah charger 110v/60 hz charging time 6~8 hours life of battery 400 cycles wheelbase 47.3 inches torque 18.45 foot pounds top speed 45 mph single charge 50 miles depending on terrain and load climbing capacity 30...

  • Page 23

    Parts list a. Horn b. Front brake c. Rear view mirror d. Head lamp e. Dash board f. Turning signal g. Rear brake handle h. Seat i. Battery box key hole j. Tail lamp k. Rear turning signal l. Rear power disk brake m. Rear shock absorber n. Charging plug o. Center stand p. Kick stand q. Front mud fend...

  • Page 24

    Assembly instructions 1. Remove the unit from its packaging. 2. Install the four 12v batteries into the battery compartment, located under the seat. Use your key to open the battery compartment. 3. Place the battery with the longest cable into the battery compartment. The cable measures 18 ½ ” in le...

  • Page 25

    4. The next battery that you want to install goes on the second tier. This is the shortest cable 11” in length (the measurements are taken from the base of the black cable to the top of the connector). Make sure the cable set aside so that you will be able to connect it. 5. The next battery that you...

  • Page 26

    6. The next step is to place the remaining battery on top of the previously installed one, this cable 14” in length (the measurements are taken from the base of the black cable to the top of the connector). Make sure the cable set aside so that you will be able to connect it. 7. Once you have placed...

  • Page 27

    8. Once installation is complete this is what it should resemble. 27.

  • Page 28

    Installing the mirrors 1. On the handle bar, in between the grips and the brake handle, screw in the mirrors. 2. Screw in the mirrors clockwise. The mirror that goes on the left controller is curved to the left and the mirror that goes on the right controller curves to the right. 3. Secure mirrors b...

  • Page 29

    Brake fluid caution brake fluid is extremely poisonous. Never allow brake fluid to b ingested or swallowed. Should brake fluid accidentally be swallowed, drink large quantities of milk or pure water and immediately seek professional medical assistance. Brake fluid is highly destructive to skin and e...

  • Page 30

    3. Remove the clear cap. 4. Remove the black filter. 30

  • Page 31

    5. Add brake fluid, dot 3 or dot 4, fill above the line on the outside of brake fluid window. 31.

  • Page 32

    Dash board a. Head lamp indicator b. Power indicator c. Signal indicator d. Speedometer e. Mileage (odometer) f. Pressure indicator g. Low voltage indicator h. Voltage (middle) i. Full voltage part item function a head lamp indicator light is illuminated when switch key and head lamp are ‘on’ b powe...

  • Page 33

    Ignition key position key position description on key cannot be taken out when power is on. To prevent theft please turn the front handle bar to the lock position and remove key from ignition. Off key cannot be taken out when power is off lock turn the handle bar to the far left and turn the key int...

  • Page 34

    Controller (left) headlight switch high beam – push switch up low beam – push switch down horizontal switch left turn signal – push switch to the left right turn signal – push switch to the right horn button sounds horn – push yellow button rear brake lever when brake handle is compressed the rear w...

  • Page 35

    Controller (right) front brake lever when brake handle is compressed the rear wheel will slow to a stop and power will be cut off. Power will flow once lever has been released. To start turn the throttle counter clockwise. Throttle turn throttle counter clockwise to increase speed. Parking lights th...

  • Page 36

    Throttle tips 5. Turn the key to the ‘on’ position, and then turn the throttle gradually to accelerate. 6. To prevent loosing control of the vehicle, please turn the throttle slowly until the vehicle increases speed. 7. Do not turn the throttle until you are in position to drive. 8. To stop, release...

  • Page 37

    Always check the battery gauge while you are riding. An emergency can occur at anytime, please stop and turn the ignition to the ‘off’ position and do not ride until the situation has been taken care of. Charging the battery for this vehicle is sealed, a maintenance free d/c battery. The owner must ...

  • Page 38

    9 point inspection before every use item action front brake squeeze brake handle on right controller and push the scooters to see if it rolls easily. If so you will need to tighten the brake. Tighten bolt until the scooter will not move with the brakes applied. Rear power/disc brake listen for any g...

  • Page 39

    Front break: drum check squeeze brake handle on right controller and push the scooters to see if it rolls easily. If so you will need to tighten the brake. Tighten bolt until the scooter will not move with the brakes applied. Rear break: disk check listen for any grinding or squealing from the tire ...

  • Page 40

    Maintenance schedule proper servicing of your motorscooter is necessary for it to achieve its normal lifetime, and to maintain its performance. Any problems that you encounter should be immediately discussed with a rad2go service technician. Mileage item 400 1000 2000 3000 4000 5000 6000 7000 8000 9...

  • Page 41

    Problem condition check solution when i turn my vehicle on nothing happens? 1. Power indicator light is off while riding. 2. Indicating light on motor is or illuminated. 1. Check power connection and battery level. 2. Check battery and motor connection. 3. Assess the weather for humidity. 4. Check r...

  • Page 42

    Warranty. Rad2go warrants each new rad2go product for ninety (90) days according to the following terms. This warranty extends to the original retail purchaser only and commences on the date of the original retail purchase. Any part of the rad2go product manufacture or supplied by rad2go and found i...

  • Page 43

    43 rad2go assumes no responsibility for incidental, consequential or other damages including, but not limited to expense of returning the rad2go product to an authorized service dealers and expense of delivering it back to the owner, mechanic’s travel, time, telephone, or telegraph charges, rental o...